Troubleshooting Guide - General
PROBLEM |
| CAUSE |
| CORRECTIVE ACTION |
|
|
| ||
Head assembly does not bevel to | 1. Bevel 33.9° stop engaged. | - Pull out 33.9° stop and rotate | ||
desired position. |
|
|
| it 90°. |
| 2. | Bevel range selector knob | - | Change range setting. |
|
| setting limits movement. |
|
|
|
|
|
| |
Blade hits table. | 1. Misalignment | - | Authorized service. | |
|
|
|
| |
Angle of cut not accurate. | 1. Misalignment | - | See Adjustments section. | |
|
|
| ||
Cannot move miter adjustment. | 1. Lock knob tightened/detent | - Loosen lock knob/move out | ||
|
| engaged. |
| of detent. |
| 2. | Sawdust under table. | - Vacuum or blow out dust. | |
| 3. | Microfine Adjustment System |
| Wear eye protection. |
| - | Disengage system. | ||
|
| is engaged. | ||
| 4. | Blade interferes with fence. | - | Authorized service. |
|
|
|
| |
Head assembly will not fully rise | 1. Part failure. | - | Authorized service. | |
or blade guard will not fully close. | 2. | Pivot spring or guard spring | - | Authorized service. |
| ||||
|
| not replaced properly after |
|
|
|
| service. |
|
|
| 3. | Cover plate not tightened | - | See Blade Installation |
|
| after replacing blade. |
| page 11. |
| 4. | Sawdust accumulation. | - | Clean head assembly. |
|
|
| ||
Blade binds, jams, burns wood. | 1. Improper operation. | - See Basic Saw Operation | ||
Rough cuts. |
|
|
| section. |
| 2. | Dull blade. | - Replace or sharpen blade. | |
| 3. | Improper blade. | - Replace with 10” diameter | |
|
| blade designed for the | ||
|
|
|
| |
|
|
|
| material being cut. |
| 4. | Bent blade. | - | Replace blade. |
|
|
|
| |
Tool vibrates or shakes. | 1. Saw blade not round. | - | Replace blade. | |
| 2. | Saw blade damaged. | - | Replace blade. |
| 3. | Saw blade loose. | - | Tighten blade bolt. |
| 4. | Other. | - | Authorized service. |
|
|
| ||
Blade does not completely cut | 1. Depth stop screw adjusted for | - See Depth Stop Adjustment in | ||
workpiece. |
| groove cutting. |
| the Adjustment section. |
|
|
| ||
Head assembly does not slide | 1. Slide rail lock knob tightened. | - Loosen slide rail lock knob. | ||
freely when attempting a slide |
|
|
|
|
cut. |
|
|
|
|
Head assembly slides forward | 2. Slide rail lock knob not | - | Push head assembly | |
and back when making a chop |
| tightened. |
| completely against stop. |
cut. |
|
|
| Tighten slide rail lock knob. |
|
|
| ||
Bevel setting does not hold | Bevel lock lever assembly needs | - Tighten bevel lock lever as | ||
position. | to be tightened. |
| shown on page 15. | |
|
|
|
|
|
37.
