Transporting, Placement & Mounting
Mounting Applications
Portable Mounting Using Clamps
Clamping
If necessary, clamp the miter saw to a workbench or Areas table top by placing two (2) or more “C” clamps on
the clamping areas and secure.
NOTE: Be careful not to place clamps over the base extension clamping levers.
Mounting with clamps will prevent access to some wide miter angles.
Clamping Areas
Figure: Portable Mounting Using Clamps
Adjusting the Four Position Switch Handle
Handle
Lock
Clamp
| Handle |
|
|
| Rotation |
|
|
| Release |
|
|
a. | Lever | c. | d. |
b. |
Figure: Setting Main Handle Position
Setting Main Handle in
Desired Position
The switch handle can be positioned in any of four different orientations, depending on the cutting situation and user preference:
a. Vertical b. 45° Left c. Horizontal d. 45° Right
To reposition the main handle:
1.Release handle lock clamp.
2.Pull and hold handle rotation release lever
3.Rotate handle to desired location.
4.Let go over release lever to set handle into place. Release lever will retract down only in one of the four (4) positions
Note: Power switch can not be actuated unless release lever is retracted down. Do not attempt to switch tool on between handle position, damage may occur.
5. Lock the handle clamp.
Adjusting the Four-Position Handle
Lock Clamp Tension
1.Open handle lock clamp.
2.Using 1.5 mm Allen wrench, increase tension by turning both setscrews 1/4 turn to the left, tighten by turning to the right. Always adjust both setscrews by the same amount.
3.Close handle lock clamp.
4.Check the tension.
20.
