Marantz PMD690 manual Recording Operation, Basic Procedure, Rec Cancel

RECORDING

Recording Operation

record settings

1 / 4

REC CANCEL

ENGLISH

REC LED

REC/MARK

STOP

Basic Procedure

1.Make sure all input selection and record settings are made correctly.

2.Press the RECORD/MARK button to enter the Record-Pause mode. The input signal will now appear in the level meter of the display and the REC LED and REC indicator in the display will flash.

R

3.If the REC LEVEL switch is set to MANUAL or LIMITER, the REC LEVEL knob will be active and allow you make adjustments to the recording level based on the input source. Refer to page 14 for information on setting the recording level.

4.When ready to record, press the RECORD/ MARK button to start recording. The REC LED and REC indicator in the display will stay steadily on and the current track number will quickly alternate with the next EDL mark number, showing that an EDL mark was placed at the beginning of the track.

REC

R

Note

• Pressing the REC/MARK button during recording will add an EDL mark at the point that the button was pressed.

5.To stop recording but then continue to record to the current track, recording must be paused and not stopped. Press the PLAY/PAUSE button to enter the record-pause mode and then press REC/MARK to resume recording.

6.When ready to stop recording and complete the current track, press the STOP button. The TOC will be updated and the unit will enter the stop mode.

Notes

•All record settings can be changed during recording except the REC MODE. If the REC MODE is changed during recording, the new setting takes effect for the next track.

•If the Auto Mark feature is active during recording, every time a track is paused an EDL mark is added.

•The REC LED will dim when the Limiter is heavily limiting the input signal.

•The minimum length of a track is 0.5 seconds. A track of less than 0.5 seconds will not be recorded on the card.

Rec Cancel

The Rec Cancel function allows a recording that is in progress to be started over in case there is a problem or the information recorded so far is not what was intended. Performing this function will result in all the information recorded up to that point in the track to be discarded.

After performing the function, the unit will re-start at the beginning of the current track and wait for recording to be started again.

1.While recording press the 1/4 (REC CANCEL) button.

The "can" message will flash as follows in the display.

REC

R

2.Press 1/4 (REC CANCEL) again within 3 seconds to perform the Rec Cancel function.

3.The PMD690 will discard the recording on the current track and re-enters the record-pause mode at the beginning of the track.

4.If the 1/4 button is not pressed within 3 seconds while the "can" message is flashing, recording will contonue as normal.

Note

• Recording will continue while the "can" message is flashing.