INITIAL SET UP
1.Connect the supplied AC power cord.
The STANDBY indicator will light in green and the projector goes into the standby mode.
2.Press the POWER ON key on the remote controller or the POWER key on the projector.
The POWER key lights in green.
3.Switch on the equipment connected to the projector. Press the INPUT SELECT key on the projector or the COMPONENT key,
4.Press the OSD key twice on the remote controller to display the FOCUS PATTERN and turn the Focus ring to make an adjustment. Adjust the focus for the sharpest image possible to obtain, using the
5.Turn the Zoom ring to adjust the size of the image. The image should fill the screen vertically with normal 4:3 aspect ratio material. If the user uses a 16:9 screen, the image will fill the screen horizontally. The use of 4:3 video source will leave black stripes on the left and right sides in the 16:9 screen. This is normal.
SET UP PROCEDURES
TO TURN OFF THE POWER
1. | Press the STANDBY key on the remote controller or the | ENGLISH |
| ||
| POWER key on the projector. |
|
2. | The fan continues to run for a while to reduce internal heat. |
|
| The POWER key flashes green and no key will be effective. |
|
| After sufficient cooling has been provided, the STANDBY |
|
| indicator lights in green. |
|
12