⁄0 ⁄3, Connector panel and Rear

Connector panel and Rear

m, v z

TRIG.1	TRIG.2	RGB IN		Y	PB/CB	PR/CR
				COMPONENT VIDEO IN			S-VIDEO
	EXT. INT.	OUT	IN				IN
				VIDEO IN
REMOTE CONTROL

b n	c		⁄2

		⁄0 ⁄3

INTRODUCTION

ENGLISH

zCOMPONENT VIDEO IN

Y, PB/CB, PR/CR connectors.

Connect to the COMPONENT VIDEO output of video equipment or an A/V processor/receiver with a component video loop.

xS-VIDEO IN

Connect to the S-VIDEO output of a video equipment.

cVIDEO IN

Connect to the composite video output of a video equipment.

vRGB IN

Connect to the analog RGB output of a computer equipment.

bREMOTE SW. (EXTERNAL/INTERNAL)

When using the MARANTZ REMOTE CONTROL system, select EXTERNAL. Otherwise select INTERNAL.

nREMOTE CONTROL IN/OUT

Connect to the REMOTE CONTROL connectors of other Marantz equipment. It is then possible to control the whole system with a single Remote Controller.

⁄0 ⁄4

⁄1

⁄2

⁄0

,TRIG.2 OUT

Either A 12-volt signal or a 0-volt signal is sent to the equipment connected to the TRIG.2 OUT, according to the setting in the OSD menu.

Note:

This cannot be used for these connectors, TRIG.1 OUT and TRIG.2 OUT, as the power source.

.Adjuster button

When using adjuster, press the button and loosen an adjuster.

⁄0Adjuster

⁄1Rear adjuster

Adjust the vertical angle of the projector.

⁄2Ventilation holes

⁄3IR sensor

⁄4AC IN

Connect the supplied AC power cord.

mTRIG.1 OUT

When the projector is turned on, a 12-volt signal is sent to the equipment connected to the TRIG.1 OUT. This allows automatic triggering of an accessory, such as a powered up/down screen, whenever the projector is turned on or off. When the unit is turned off, no voltage is output and when the unit is turned on, 12 V is output.

Note:

You cannot use the connector as the power source.