MS4000 EN 3/5/03 8:46 AM Page 6
Getting Started
EN | Unpacking the system: | Connecting the Speakers | ||
Match the red wire (on the left speaker) to red termi- | ||||
| You should have the following: | |||
| • | one main unit (with 2 main speakers); | nal for the left speaker (L) on the back of the unit and | |
| • | one remote control; | the black wire (on the left speaker ) to the black ter- | |
| • | one AM loop antenna; | minal for left speaker (L). Follow the same procedure | |
| • | one FM antenna wire | to connect the right (R) speaker. | |
| • | one user’s guide; |
| |
| • | One Thomson Warranty Card | Antenna and Speaker Wire Connection | |
|
|
| ||
Back View
OPTICAL OUT
4 | 1 | AM LOOP |
2 
| + |
|
| R | Ω |
3 | _ _ | 6SPEAKERS |
| L | MAIN |
~ | + |
|
|
|
1.AM Loop Antenna Jacks
2.FM Antenna Connector
3.Main Speaker Jacks
4.Optical Out Connector
Using the FM and AM Antennas
Before you use your audio system, you’ll want to make sure both the FM and AM antennas are posi- tioned properly. Connect the FM antenna to the FM connector on the back of the unit. Uncoil it, making sure it is fully extended. (you may even want to tape it to the wall behind the unit if possible. The higher the better.)
You’ll also need to connect the AM antenna loop to the back of the unit if you listen to AM stations. Rotate the AM loop antenna for better reception.
Push terminal tab down to | Release tab to lock wire in |
insert wire. | the terminal. |
NOTE: Make sure the insulation is completely removed from the ends of the Antenna and speaker wires at all connection points.
Installation
To ensure sufficient ventilation, keep the spacings shown below free from other surfaces:
| 10 cm |
10 cm | 10 cm |
| 5 DISC CHANGER |
Front View
10 cm
5 cm
Side View
2