Technicolor - Thomson MS4000 manual EN Remote Control, Installing Batteries

MS4000 EN 3/5/03 8:46 AM Page 8

Controls and Indicators

EN Remote Control

TUNER	SOURCE	TAPE
CD		AUX

	E Q	B.BO
			OST
ON•ECO			X-SURROUND
	VOL
PR			NEXT
EV
RE			D
V
			FW
	VOL
RECORD			STOP
REPEAT•RDS			PTY
FM ST.	DISC SKIP		INTRO•CT
DN•PRESET•UP			SLEEP

Battery Size:

“AAA” or “UM-4” or “R03”

ON•ECO — keep pressing briefly STANDBY mode to enter ECO (power saving, without clock display) mode.

CD — Selects CD player. TUNER — Selects radio tuner. TAPE — Selects tape player. AUX — Selects external input. EQ— Selects equalizer presets. B.BOOST — Turns on or off Bass Boost. X-SURROUND— Activates SURROUND.

VOL+ or VOL- — Increases/ decreases volume. PLAY/PAUSE — Plays and Pauses the CD or tape.

NEXT	/ FWD	— In CD mode - Increments CD track and set-
ting options; searches forward through CD;
In Tuner mode - tunes up radio frequency;
In Tape mode - fast forwards tape.
PREV	/REV	— In CD mode - Decrements CD track and

setting options; searches backward through CD; In Tuner mode - tunes down radio frequency; In Tape mode - rewinds tape.

RECORD — Starts tape recording. STOP — Stops CD and tape playback.

REPEAT•RDS — Repeats a track, CD, or all CDs. When the radio is active, displays RDS information.

MUTE — Mutes volume.

/PTY — Turns on/off random listening, selects search by program type in tune mode.

FM ST. — Toggles between FM stereo and mono. DISC SKIP — Skips to next CD.

INTRO•CT — Turns INTRO mode on or off to play the first 10 sec- onds of each track, shows RDS time.

PRESET UP/DOWN — Selects next/ previous preset station. SLEEP — Press to select the time interval in minutes before the unit turns off.

Installing Batteries

The remote control must be inserted with 2 “AAA” or “R3” or “UM 4” batteries prior to use. Follow the steps below to ensure correct installation.

1.Open the battery compartment door (located at the back of the remote control) by sliding the cover out.

2.Before inserting the batteries, observe the polarities (that is, +

and -) of the battery then relate the polarities to the engraved dia- gram inside the battery compartment. Now insert the batteries.

3.After installation of the batteries, place the lit to cover the bat- teries. Lightly push it closed with a snap.

4