Tuner

MS4000 EN 3/5/03 8:46 AM Page 12

EN Selecting Tuner

1.Press SOURCE to select TUNER.

2.Press BAND to select between FM/MW/LW radio band.

Tip: Your audio system has 32 preset stations.

4.The most recently accessed program location will be displayed.

5.If a different program location is preferred, press

SKIP BACKWARD / SKIP FORWARD to move to the desired preset number (1-32).

6.Press PROG•SET to store the selected frequency at that preset.

Tuning to a Station

Press SKIP BACKWARD / SKIP FORWARD to select frequencies.

Suppressing Stereo Signal

Press FM ST to toggle between FM mono and stereo for stereo FM stations. (Remote Only)

87.50 MHz	Tuning to an RDS Station

Using Presets

The tuner can be either TUNE or PRESET mode. When in PRESET mode, the PROG light is on.

•Press TUNE•PRESET to toggle between Preset and Tune mode.

• Press SKIP BACKWARD

/ SKIP FORWARD

or PRESET UP or PRESET DOWN on the remote

control to access the previous or next preset station. The display first shows the preset program number and after a few seconds, the frequency will be dis- played. (FMPR:01 is FM preset 1)

PR:01

Tip: RDS stations broadcast on FM only. When the tuner detects an RDS signal, the RDS icons turns on.

1. Press TUNE•PRESET to access preset station or

press SKIP BACKWARD / SKIP FORWARD to desired frequency.

2.If RDS station found, RDS lights on display with station name shown.

Displaying RDS Station Information

Press CLOCK/RDS on the main unit or REPEAT•RDS on the remote control to display the frequency, sta- tion name (PS), station type (PTY), clock time (CT), or radio text (RT). In CT mode, press INTRO•CT key to replace the displayed time by RDS station time. If clock time is not yet set, this information will be shown as clock time automatically.

Auto Preset Programming (for FM only)

Press and hold BAND/AUTO PROG./DECK1•2 button for 2 second to scan stations in the selected band. The stations will then be stored as preset channels. A maximum of 32 stations can be stored. Beware of your preset channels being erased accidentally because the scanning and storing process is automatic upon pressing the button.

You can stop the automatic scan by pressing any but- ton, but the erased stations cannot be recovered.