Replacing the Light-Source Lamp (Cont.)
2 Loosen the lamp-unit screws, raise the handle, and pull out the lamp unit.
Loosen the two screws with a flat-end screwdriver.
Note
•The screws are fitted so that they do not come off the lamp- unit.
Screw
Lamp unit
2
1 
3 Insert the new lamp unit fully inside and fasten the screws.
Fasten the two screws with a flat-end screwdriver.
CAUTION
•Do not touch the glass surface of the light-source lamp directly with your hand as well as staining it. If you touch with a bare hand, stains on your hand may adhere to the lamp, possibly preventing the lamp from performing as specified due to a shortened lamp life, a darkened screen, etc. To handle a new light-source lamp, hold its plastic part. Never touch the metal part or the front glass surface.
Handle
Lamp unit
1
2
ENGLISH
| Replace the lamp-replacement | Lamp-replacement |
| 4 opening cover and fasten the |
| opening cover |
| |
| screws. | |
Fasten the two screws with a flat-end screwdriver.
Be careful not to damage the claw.
CAUTIONS
•Install the lamp unit and close the lamp-replacement opening cover correctly; otherwise, a safety switch is activated to prevent the projector from operating.
•If the claw on the lamp-replacement opening cover is damaged, the projector may not possibly operate. Then, replace with a new lamp-replacement opening cover.
•After replacing the lamp, be sure to reset the lamp use time (see page 50).
