Setting for the external control External Control on

Operation guide

Shows the buttons for each operation.

•The menu automatically disappears in about 30 seconds after the previous operation.

•Some items may not appear on the menu depending on the input or the input signal.

•The items controlled by the MAKE system do not appear on the menu.

Setting for the external control (☞ “External Control” on page 13)

Item	To do	Setting value
SYSTEM	Select the external control method for the MAKE/	MAKE, TRIGGER
	TRIGGER terminal.
PORT F1 – PORT	Assign the control functions to the pins of the	VIDEO 1, VIDEO 2, RGB, DVI,
F6	MAKE/TRIGGER terminal.	STD., DARK ENHANCED, VIVID,
	• You cannot change the functions assigned for	DYNAMIC, AUTO ADJ., SCAN SIZE,
	“PORT F7” and “PORT F8.”	ASPECT, STAND BY/ON, – – – (no
		function)

		12

SYNC FUNCTION
Setting for the synchronization with signals

Item	To do	Setting value
SYNC TYPE	Select the sync signal for RGB input.	H/V. SYNC, C.SYNC, G.ON SYNC
NO SYNC ACTION	Select the screen status when no signal is	OFF, POWER SAVE (Power Save mode),
	coming in.	GRAY BACK (Gray Back mode)
DELAY TIME	Select the period until the screen status	30 sec., 5 min., 15 min.
	changes as selected in “NO SYNC ACTION”
	after signals stop coming in.

STATUS DISPLAY Setting value: AUTO, OFF

Turns on (or off) the control lock function to disable the buttons on the front panel.

•The following operations are available even when this function is activated.

–Turning on/off (on standby) the monitor

–Displaying the SET UP MENU (by pressing button while pressing MENU button) and turning “CONTROL LOCK” to “OFF”

–Operating the monitor by an external control

If you try other operations, “Control lock on!” appears on the screen.

Restores all the settings and adjustments of the monitor to the default.

• “HOUR METER X100h” will not be reset.

Displays the total hours of use. This item is used for maintenance of the monitor.

•The hour is shown in 100-hour unit.

•The hour will not be reset.

•The hour is reset to “000” after the total hours of use have reached to “999.”

•Use time less than 1 minute is not accumulated.

• “STAND BY/ON” is not available when “SYSTEM” is “MAKE.”