Daily Operations / Connections (cont.)
8
7Rear panel
1 |
Security slot
Install a security wire to this slot.
The illustration of the monitor is of
2 |
3 |
4 |
5 |
6 |
7 |
Note for connections
•Before making any connections, turn off all the equipment.
•Use a cord whose plugs correctly match the terminals on this monitor and the equipment.
•Plugs should be firmly inserted; poor connections could cause noise.
•When unplugging a cord, be sure to grasp its plug and pull it out.
•DO NOT connect the power cord until all connections are completed.
•Refer also to the user manual of each piece of equipment.
1AC IN terminal
AC power input connector.
•Connect the provided AC power cord to an AC outlet.
2REMOTE terminal (MAKE/TRIGGER) Terminal for controlling the monitor by an external control.
☞ “External Control” on page 13
3RGB terminals
Input terminal for the analog RGB signals.
•Use the AUDIO INPUT RGB terminal (7) for audio connection.
4DVI-D terminal
Input terminal for the
•Use the AUDIO INPUT
5VIDEO 2 IN/OUT terminals
Input (IN) and output (OUT) terminals for the composite signals.
•Use the AUDIO INPUT VIDEO 2 terminal (7) for audio connection.
6VIDEO 1 IN/OUT, Y/C terminals
Input (IN) and output (OUT) terminals for the composite signals and input terminal for S- video signals (Y/C).
•When both the IN and Y/C terminals are used, signals to the Y/C terminal have priority.
•Use the AUDIO INPUT VIDEO 1 terminal (7) for audio connection.
7AUDIO INPUT VIDEO 1/VIDEO 2/RGB/DVI-D terminals
Input terminals for the analog audio signals.
•Use the video terminal with the same name for video connection.
Attaching the Ferrite Core
Attach the ferrite core to the power cord.
• Using the power cord without the ferrite core may lead to noise (interference).
1 Open the ferrite core, insert the power cord | 2 Attach the ferrite core to the AC IN end of |
and close the ferrite core. | the power cord. |
Ferrite core |
|
Power cord |
|
| To the AC IN |
| terminal |