Onkyo S5100 instruction manual Making Hdmi Connections, Audio Signals, Tip, DVD player Step

Connecting Your Components—Continued

Making HDMI Connections

If you have an HDMI-compatible player, you can connect it to the AV receiver with an HDMI cable.

Step 1: Connect your HDMI-compatible TV to the AV receiver’s HDMI OUT jack.

Step 2: Connect your HDMI-compatible player to the AV receiver’s HDMI IN 1, 2, or 3 jack.

Step 3: Connect your HDMI-compatible player to an analog and/or digital audio input on the AV receiver.

Step 4: Assign the HDMI IN.

Turn on the AV receiver, and then assign the HDMI IN (see page 44).

■Audio Signals

•Audio and video signals received via inputs other than the HDMI IN jacks are not output by the HDMI OUT.

•Audio and video signals received via the HDMI IN jacks are output only by the HDMI OUT.

•To watch an HDMI source that’s connected via the AV receiver’s HDMI jacks, the AV receiver must be turned on, otherwise no HDMI signal will be output.

•If you want to listen through the speakers connected to the AV receiver, in addition to an HDMI connection, you’ll also need to make a separate analog or digital audio connection.

DVD player

Step 3 ✽

HDMI	HDMI
OUT	IN
	TV
Step 2	Step 1
IN 1

HDMI

ASSIGNABLE

Connect one or the other

	HDMI	IN 3	IN 2
	ASSIGNABLE
DIGITAL IN	COMPONENT VIDEO

			Y
1
(DVD)
COAXIAL			CB/ PB
2
(CBL/SAT)
			CR/ PR
1
(VCR/DVR)
OPTICAL	IN 1(DVD)	OUT
IN 2
2	ASSIGNABLE
(CD)	IN	OUT	IN
ASSIGNABLE
	L
	R
REMOTE
CONTROL
	CD		TAPE

IN 1	OUT
DOCK				SIRIUS	AM
CBL/SAT	VCR/DVR		DVD	MONITOR
				OUT
V					V
					ANTENNA
					FM
S					75
					S
IN	OUT	IN	IN
IN	OUT	IN	FRONT	SURR	CENTER SURR BACK
L					L
R					R
					SUB
CBL/SAT	VCR/DVR			DVD	WOOFER

Tip!

If you make the connection described in step 3, to fully enjoy the AV receiver's lis- tening modes, turn down the volume on your TV all the way so that its speakers output no sound.

Sound off

Notes:

•The HDMI video stream is compatible with DVI (Digital Visual Interface), so TVs and displays with a DVI input can be connected by using an HDMI-to-DVI adapter cable. (Note that DVI connections only carry video, so you’ll need to make a separate connection for audio.) However, reliable operation with such an adapter is not guaranteed. In addition, video signals from a PC are not supported.

•When listening to an HDMI component through the AV receiver, set the HDMI component so that its video can be seen on the TV screen (on the TV, select the input of the HDMI component connected to the AV receiver). If the TV power is off or the TV is set to another input source, this may result in no sound from the AV receiver or the sound may be cut off.

•The HDMI audio signal (sampling rate, bit length, etc.) may be restricted by the connected source component. If the picture is poor or there’s no sound from a component connected via HDMI, check its setup. Refer to the connected component’s instruction manual for details.

36