Onkyo S5100 instruction manual Playing Your AV Components, Basic AV Receiver Operation

Playing Your AV Components

Basic AV Receiver Operation

Subwoofer’s

MASTER VOLUME

ON/STANDBY TUNING PRESET

rear panel

STANDBY

1

DOCK

MULTI CH

DVD

VCR/DVR

CBL/SAT AUX

TAPE

TUNER

CD

SETUP

RETURN

3

4

INPUT

PHONES

SETUP MIC

VIDEO

AUX L AUDIO R

A SPEAKERS B

TONE

MOVIE/TV MUSIC

GAME

DISPLAY DIGITAL INPUT

RT/PTY/TP MEMORY TUNING MODE

AV RECEIVER HT-R560

MIN

MAX

1

3

OUTPUT LEVEL

1		Remote
		controller
AV receiver
DVD	VCR/DVR	CBL/SAT
AUX	TAPE	TUNER
CD

Use the AV receiver’s input selector buttons to select an input source.

To select an input source with the remote controller, press its INPUT SELECTOR buttons.

To listen to a DVD player connected to the multichannel DVD input (page 31), press the AV receiver’s [MULTI CH] button. The MULTI CH indicator will appear on the display.

Note:

•While the multichannel DVD input is selected, the Speaker Configuration settings on page 77 are ignored, and signals from the multichannel input are fed to the speakers as they are.

2

AV receiver	Remote
	controller
A SPEAKERS B

SP A / B

Use the SPEAKERS [A] and [B] buttons on the AV receiver or the [SP A/B] button on the remote controller to select the speaker set that you want to use.

Pressing the remote controller’s [SP A/B] button cycles through the following settings: Speaker Set A → Speaker Set A&B → Speaker Set B → Off.

The A and B speaker indicators show whether each
speaker set is on or off.	Indicators

Note that when speaker set B is turned on, speaker set A is reduced to 5.1-channel playback.

3	Start playback on the source component.
	To watch a DVD or other video source, on your TV, select the video input that’s con-
	nected to the AV receiver’s COMPONENT VIDEO OUT, HDMI OUT, or MONITOR
	OUT.
	On some DVD players, you may need to change the digital or HDMI audio output
	settings.

4

AV receiver	Remote
MASTER VOLUME	controller

To adjust the volume, use the MASTER VOLUME control or the remote controller’s [VOL] button.

Since the AV receiver is designed for home theaters, it has a wide volume range for precise adjustment. The volume can be set to Min, 1 through 79, or Max.

Note: When the subwoofer volume level is set to a positive (+) value, the maximum master volume level is reduced proportionally.

To set the level of the subwoofer, use the OUTPUT LEVEL control.

Because our ears are less sensitive to very low bass sounds, there’s a temptation to set the level of the subwoofer too high. As a rule of thumb, set the subwoofer level to what you think is the optimal level, and then back it off slightly.

5	Select a listening mode and enjoy!
	See “Using the Listening Modes” on page 67.

47