Onkyo S5100 instruction manual Recording the Input Source, Recording from Different AV Sources

Recording

This section explains how to record the input source and how to record audio and video from separate sources.

Notes:

•The surround sound and DSP listening modes cannot be recorded.

•Copy-protected DVDs cannot be recorded.

•Sources connected to the analog multichannel input cannot be recorded.

•Sources connected to a digital input cannot be recorded. Only analog inputs can be recorded.

•DTS signals will be recorded as noise, so don’t attempt analog recording of DTS CDs or LDs.

•While the Pure Audio listening mode is selected, the VCR/DVR OUT V and S jacks don’t output video sig- nals, so select another mode when recording.

Recording the Input Source

Audio sources can be recorded to a recorder (e.g., cas- sette deck, CDR, MD) connected to the TAPE OUT jack. Video sources can be recorded to a video recorder (e.g., VCR, DVR) connected to the VCR/DVR OUT jacks. See pages 27 to 40 for hookup information.

Recording from Different AV Sources

You can overdub audio onto your video recordings by simultaneously recording audio and video from two sep- arate sources. This is possible because only the audio source is switched when an audio-only input source, such as TAPE, TUNER, or CD, is selected, the video source remains the same.

In the following example, audio from the CD player con- nected to the CD IN and video from the camcorder con- nected to the AUX INPUT VIDEO jack are recorded by the VCR connected to the VCR/DVR OUT jacks.

AUX INPUT

VIDEO L AUDIO R

Camcorder

video signal audio signal

	HDMI	IN 3	IN 2
	ASSIGNABLE
DIGITAL IN	COMPONENT VIDEO

IN 1 OUT

1

DVD VCR/DVR CBL/SAT

AUX TAPE TUNER

CD

Remote

Use the input selector buttons to select the source that you want to record.

See “Which Connections Should I Use?” on page 28 to see which signals can be output and recorded.

You can watch the source while record- ing it. The AV receiver’s MASTER

			Y
1
(DVD)
COAXIAL			CB/ PB
2
(CBL/SAT)
			CR/ PR
1
(VCR/DVR)
OPTICAL	IN 1(DVD)	OUT
IN 2
2	ASSIGNABLE
(CD)	IN	OUT	IN
ASSIGNABLE
	L
	R
REMOTE
CONTROL
	CD		TAPE

DOCK				SIRIUS	AM
CBL/SAT	VCR/DVR		DVD	MONITOR
				OUT
V					V
					ANTENNA
					FM
S					75
					S
IN	OUT	IN	IN
IN	OUT	IN	FRONT	SURR	CENTER SURR BACK
L					L
R					R
					SUB
CBL/SAT	VCR/DVR			DVD	WOOFER

controller

VOLUME control has no effect on recording.

CD playerVCR

2	On your recorder, start record-
	ing.
3	On the source component, start
	playback.

Note:

•If you select a different input source during recording, that input source will be recorded instead.

1	Prepare the camcorder and CD player for
	playback.
2	Prepare the VCR for recording.
3	Press the [AUX] input selector button.
4	Press the [CD] input selector button.
	This selects the CD player as the audio source but
	leaves the camcorder as the video source.
5	Start recording on the VCR, then start
	playback on the camcorder and CD player.

Video from the camcorder and audio from the CD player are recorded by the VCR.

73