Onkyo S5100 Connecting Onkyo Components, Connecting the Power Cord, Auto Power On/Standby

Connecting Your Components—Continued

Connecting Onkyo Components

Step 1: Make sure that each Onkyo component is connected to the AV receiver with an analog audio cable (RCA).

Step 2: Make the necessary connections (see illustration below).

Step 3: If you’re using an MD or CDR component, change the Input Display (see page 46).

With (Remote Interactive), you can use the following special functions:

Auto Power On/Standby

When you start playback on a component connected via , if the AV receiver is on Standby, it will automatically turn on and select that component as the input source. Similarly, when the AV receiver is set to Standby, all components

connected via will also go on Standby.

Direct Change

When playback is started on a component connected via , the AV receiver automatically selects that component as the input source. If your DVD player is connected to the AV receiver’s DVD IN (multichannel input), you’ll need to press the [MULTI CH] button repeatedly and select Multich to hear all channels (see page 47), as the Direct Change function selects the DVD IN FRONT L/R jacks.

Remote Control

You can use the AV receiver’s remote controller to control your other -capable Onkyo components. You must enter the appropriate remote control code first (see page 83). And remember to point the remote controller at the AV receiver and not the other component.

Notes:

•	Use only	cables for	connections.				cables
	are supplied with Onkyo players (DVD, CD, etc.).
•	Some components have two				jacks. You can con-
	nect either one to the AV receiver. The other jack is
	for connecting additional			-capable components.
•	Connect only Onkyo components to					jacks. Con-
	necting other manufacturer’s components may cause
	a malfunction.

	HDMI	IN 3	IN 2
	ASSIGNABLE
DIGITAL IN	COMPONENT VIDEO

				Y
	1
	(DVD)
	COAXIAL			CB/ PB
	2
	(CBL/SAT)
				CR/ PR
	1
	(VCR/DVR)
	OPTICAL	IN 1(DVD)	OUT
	IN 2
	2	ASSIGNABLE
	(CD)	IN	OUT	IN
	ASSIGNABLE
		L
REMOTE		R
	REMOTE	CD		TAPE
CONTROL	CONTROL

						IN
IN 1	OUT					L
DOCK				SIRIUS	AM	R
				MONITOR
CBL/SAT	VCR/DVR		DVD
				OUT
V						CD
					V
					ANTENNA
S					FM
					75
					S
IN	OUT	IN	IN
IN	OUT	IN	FRONT	SURR	CENTER SURR BACK	FRONT
L
					L
R						L
					R
					SUB
CBL/SAT	VCR/DVR			DVD	WOOFER
						R
						DVD

• Some components may not support all	functions.
Refer to the manuals supplied with your other Onkyo
components.

e.g., CD player

R L

ANALOG

AUDIO OUT

e.g., DVD player

R L

ANALOG

AUDIO OUT

Connecting the Power Cord

•Before connecting the power cord, connect all your speakers and AV components.

•Plug the end of the power cord into a suitable wall outlet.

•Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical equipment on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.

40