JVC DLA-M5000SCU, DLA-M5000LU manual Connector Panel

Controls and Features (cont.)

Connector Panel

			1	2
			Y/C	VIDEO
8	RGB	RGB IN-1
	R	RGB IN-2	EXT. IN	Y
7	G	H/CS		PB/B-Y	3
	B	V		PR/R-Y
			REMOTE
	RGB OUT			CONTROL
		RS-232C
	6	5	4

1Y/C (S video) input terminal (Mini DIN 4 pin)

Connect this terminal to the S video output terminal of a video deck, etc.

*This terminal can be used if a video board (PK-G1101D) sold separately has been installed. The terminal was not provided when the projector was shipped from the factory.

2VIDEO (composite video) input terminal (BNC) Connect this terminal to the composite video output terminal of a video deck, etc.

*This terminal can be used if a video board (PK-G1101D) sold separately has been installed. The terminal was not provided when the projector was shipped from the factory.

3Y, PB/B-Y, PR/R-Y input terminals (BNC)

These are input terminals for component (Y, B-Y, R-Y) signals or DTV-format (Y, PB, PR) signals.

Device with component signal output terminals, such as for NTSC and DTV-format, can be connected.

*For details about DTV-format signals (480i, 480p, 720p, 1080i) compatible with this unit, refer to page 66.

4REMOTE terminal (mini jack)

This terminal is used to directly connect the remote con- trol to the projector. Use the remote control cable supplied. An infrared remote control extension unit can also be con- nected to the jack.

5RS-232C terminal (D-sub 9 pin)

This is a RS-232C interface-specified terminal. This projector can be controlled by a computer connected externally.

6RGB OUT (RGB output) terminal (D-sub 3-row 15 pin) The computer input signal projected on the screen is output. A display unit can be used by connecting it to this terminal.

7RGB IN (RGB input) -2 terminal (BNC)

These are input terminals for analog RGB signals, vertical sync (V) signals, and horizontal sync (H) signals / composite signals(Cs). Devices which have analog RGB signal output terminals can be connected.

*Input of external sync signals is automatically detected.

Detection of H/V signals or Cs signals causes automatic switch to external sync. The priority order is H/V > Cs.

CAUTION

•When computer-related signals are input, the uppermost edge of the screen may appear bowing if the sync signal input is composite sync (Cs) or G on sync signal. In that case, use separate sync signals for vertical sync (V) and horizontal sync

(H).

8RGB IN (RGB input) -1 terminal (D-sub 3- row 15 pin) This is an input terminal (PC) dedicated for computer signals (RGB video signals and sync signals).

Connect the display output terminal of the computer to this terminal. When a Macintosh or PC-9801/9802 series computer is to be connected, use a suitable conversion adapter separately available.

CAUTION

•When computer-related signals are input, the uppermost edge of the screen may appear bowing if the sync signal input is composite sync (Cs) or G on sync signal. In that case, use separate sync signals for vertical sync (V) and horizontal sync

(H).

10