Onkyo DR-90 instruction manual Symptoms Causes Remedies, Tuner Remote controller Recording

Troubleshooting (continued)

Symptoms Causes Remedies Pages

Too much noise is heard or sound is interrupted occasionally. (“STEREO” indicator does not light steadily.)

•FM stereo waves may produce a hiss noise when a certain level is reached.

•The position or direction of the FM aerial is incorrect.

•The station is too weak.

• Switch the frequency receiving mode to	26
mono.
• Lower the treble level.	29
• Adjust the position, height, and direction	14
of the FM aerial.
• Connect an outdoor FM aerial. Try to use	15
an aerial with more elements.
(For installation of the outdoor aerial,
consult your nearest dealer as it requires
special skills and experience.)

Tuner

Remote controller Recording

Sound is distorted or	• The radio wave is distorted.	–	–
sound volume decreases.	• Cars are running or airplanes are flying	–	–
	near the house.
Sound is excessively	• There is a tall building or a mountain	–	–
distorted.	nearby.
	[The waves transmitted from the
	transmission center (direct waves) and
	the waved diffracted by buildings or
	mountains (diffraction waves) interfere
	with each other causing multi pass
	distortion.]
No preset channels are	• The mains lead is unplugged, or the main	• The preset data in memory is lost. Preset	26
selected.	power is switched off, for a long time.	the radio stations again.
Sound is reproduced from	• The sound system you are trying to	• DTS Surround sound is unable to be	41, 59
the speakers but not	record is DTS Surround.	recorded regardless of the sound signal
recorded.		conversion method.
	• A wrong sound signal conversion method	• Check the current sound signal	40, 41,
	is selected.	conversion method and select the right	50, 59
		one for recording.
The buttons on the DVD	• No batteries are inserted in the remote	• Insert new batteries.	8
Receiver operate but the	controller.
buttons on the remote	• The batteries are worn out.	• Replace with new batteries.	8
controller do not operate.	• The remote controller is not pointed at the	• Point the remote controller at the remote	8
	remote sensor of the DVD Receiver.	sensor of the DVD Receiver.
	• The remote controller is too far from the	• Operate the remote controller within 5 m.	8
	DVD Receiver.
	• The DVD RECEIVER/LEVEL SETUP/TV	• Set the switch to the right position.	8
	switch is set to the wrong position.

This unit contains a sensitive microcomputer, which under certain circumstances might fail to operate due to excessive noise interference. If this happens, press the DVD Receiver’s VIDEO 1 button and STANDBY/ON button at the same time until “CLEAR” appears in the DVD Receiver’s display. The DVD Receiver turns into the standby mode, then all the custom settings in the DVD Receiver’s memory will be erased. Please repeat the custom settings from the beginning.

62