Onkyo HT-S580 Advanced Setup, Advanced Speaker Settings, Crossover Frequency, Double Bass

Page 50

Advanced Setup

Advanced Speaker Settings

The advanced speaker settings cannot be changed while headphones are connected, Speaker set B is on, or the multichannel input is being used.

Crossover Frequency

To get the best bass performance from your speaker sys- tem, you need to set the crossover frequency according to the size and frequency response of your subwoofer and other speakers (front, center, and surround).

1

Press the [RECEIVER] button fol-

 

 

lowed by the [SETUP] button on

 

the remote controller.

2 Use the Up and Down []/[ ] buttons to select “1. Speaker Config,” and then press the [ENTER] button.

3

Use the Down [ ] button to

 

select “Crossover,” and then use

the Left and Right []/[ ] but- tons to select a crossover fre- quency.

Choose a crossover frequency suitable for your setup.

If you’re using a subwoofer, choose a

crossover frequency based on the diam- eter of your front speakers.

If you’re not using a subwoofer, use the diameter of the first speaker that you specified as Small in steps 4 through 7 in the “Speaker configura- tion” setting (see page 34).

Speaker cone

Crossover

diameter

frequency

 

 

Over 8 in.

60Hz

(20 cm)

 

 

 

6-1/2 to 8 in.

80Hz

(16–20 cm)

 

 

 

5-1/4 to 6-1/2 in.

100Hz

(13–16 cm)

 

 

 

3-1/2 to 5-1/4 in.

120Hz

(9–13 cm)

 

 

 

Under 3-1/2 in.

150Hz

(9 cm)

 

 

 

Continue with step 4 of the “Double

Bass” setting.

Note:

•For a more accurate setting, listen to some music that you know well and choose a higher crossover fre- quency if you think there’s not enough sound coming from the subwoofer; a lower setting if you think there’s too much.

Double Bass

With the Double Bass function, you can boost bass out- put by feeding bass sounds from the front left and right channels to the subwoofer. This function can be set only if the Subwoofer setting (step 3) is set to Yes, and the Front setting (step 4) is set to Large in the Speaker Con- figuration on page 34.

4

Use the Down [ ] button to

 

select “Double Bass,” and then

use the Left and Right []/[ ] buttons to select:

On: Double Bass function on. Bass from the front left and right channels is also fed to the subwoofer (default).

Off: Double Bass function off.

5

Press the [SETUP] button.

 

 

Setup closes.

50

Page 49 Page 51
Image 50
Page 49 Page 51
Contents
HT-S580 Important Safety Instructions AvisPrecautions PowerPlacement Speaker PrecautionsPrecautions Using Close to a TV or ComputerFeatures Table of ContentsSupplied Accessories HT-R330 HTP-330Installing the Batteries Before Using the AV receiverSetting the Voltage Selector on some models Using the Remote ControllerFront & Rear Panels Front PanelFront & Rear Panels DisplayRear Panel Voltage Selector only some modelsKeyhole slots Speaker PackageRear Speaker terminals Speaker mount/bracket insertsReceiver Mode Remote ControllerHow to Use the Remote Controller Remote Controller DVD Mode CD, MD, & CDR Mode CDRStop button Tape ModePlay button Reverse Play buttonConnecting Your Speakers Enjoying Home TheaterConnecting Speaker Connecting Your SpeakersSpeaker Connection Precautions Wall Mounting Using Speaker Mounts/BracketsUsing Rubber Stoppers with the Speakers Front speaker SKF-330F Surround speaker SKM-330SConnecting the AM Loop Antenna Connecting AntennaConnecting the Indoor FM Antenna Attach the FM antenna, as shown American ModelConnecting an Outdoor AM Antenna Connecting AntennaConnecting an Outdoor FM Antenna Using a TV/FM Antenna SplitterOptical Digital Jacks Connecting Your ComponentsAbout AV Connections AV Connection Color CodingWhich Connections Should I Use? Connecting Your ComponentsConnecting Both Audio & Video Audio Connection FormatsAudio Connection Connecting a TV or ProjectorVideo Connection HintDVD in Video Connecting a DVD playerDVD player Connection Composite video outputDVD recorder Connection Connecting a VCR or DVD Recorder for PlaybackVCR Video 1 in VideoConnecting a VCR or DVD Recorder for Recording Connecting a Camcorder, Games Console, or Other DeviceOr the other Video 2 in VideoConnect one Satellite, cable Set-top box, etcTurntable MM with built-in phono preamp Connecting a CD Player or TurntableCD Player, or Turntable with Built-in Phono Preamp Step Phono Preamp MC head amp or MC transformerConnecting a Cassette, CDR, MiniDisc, or DAT Recorder Cassette recorder, CDR, etcAuto Power On/Standby Connecting Onkyo ComponentsConnecting the Power Cord Direct ChangeSmooth Operation in a Few Easy Steps Turning OnTurning On the AV Receiver Have you connected a component to a digital audio input?Changing the TAPE/MD/CDR Display First Time SetupAssigning Digital Inputs to Input Sources Speaker Configuration First Time SetupLowed by the Setup button Press the Receiver button folPress the Setup button Press the remote controller’s Test Tone butBasic AV Receiver Operation Select a suitable listening mode and enjoyPlaying Your AV Components Start playback on the source componentDisplaying Source Information Using the Multichannel InputPlaying Your AV Components Interpreting Surround Channel InformationAM Frequency Step Setup Not North America and Europe Using the TunerTuning into Radio Stations Listening to the RadioDeleting Presets Using the TunerPresetting Radio Stations Selecting Preset StationsProgram Types Used in Europe PTY Using RDS European models onlyWhat is RDS? Listening to Traffic News TP Displaying Radio Text RTFinding Stations by Type PTY Adjusting the Bass & Treble Using the OptiResponse EqualizerSetting the Display Brightness Common FunctionsAdjusting Speaker Levels Using the Sleep TimerUsing Headphones Common FunctionsSelecting Listening Modes Using the Listening ModesSelecting with the Remote Controller Selecting on the AV receiverUsing the Listening Modes DTS-ESDTS About the Listening ModesOnkyo Original DSP Modes Input Channel Settings Adjusting the Listening ModesUsing the Audio Adjust Functions Using the CinemaFILTER Adjusting the Listening ModesUsing the Late Night Function Dolby Digital only PL II Music Mode SettingsRecording from Different AV Sources RecordingRecording the Input Source Crossover Frequency Advanced SetupAdvanced Speaker Settings Double BassSpeaker Levels Advanced SetupSpeaker Distance Digital Input Signal Formats Troubleshooting Troubleshooting Can’t control other components? Remote controller doesn’t work?Sound changes when I connect my head- phones? Can’t record?Video Section SpecificationAmplifier Section Tuner SectionSpecification 1ch Home Theater Speaker PachageMemo Memo Onkyo Europe UK Office Onkyo U.S.A. CorporationOnkyo Europe Electronics GmbH Onkyo China Limited