Elmo CRP-26 Image is distorted or runs off, PIN code dialog box appears, At start-up, Not work

	Appendix
The image is distorted or runs off.	– Check PC adjust menu or Screen menu and adjust them.
	See pages 30-31, 34-35.
PIN code dialog box appears	– PIN code lock is being set. Enter a PIN code (the “1234” or numbers
at start-up.	you have set). See pages 19, 53-54.
The Remote Control does	– Check the batteries.
not work.	– Make sure no obstruction is between the projector and remote
	control.
	– Make sure you are not too far from the projector when using the
	remote control. Maximum operating range is 16.4'(5 m).
	– Make sure the code of the remote control is conformed to the
	projector’s code. See page 52.
	– Unlock the Key lock function for the remote control function. See
	page 53.
Indicator blinks or lights.	– Check the status of the projector with referring to "Indicators and
	projector Condition". See page 69.
The exclamation mark appears	– Your operation is invalid. Operate correctly.
on the screen.

Top control does not work.

–The top control is not available if the top control is locked at Key lock under Security of SETTING section. See page 53.

Unable to unlock the Logo PIN code lock, Security key lock or Security PIN code lock.

–Contact the dealer where you purchased the projector or the service center.

65