Onkyo HT-S3300 Troubleshooting, Can’t turn on the AV receiver, Standby indicator flashes red

Page 47

Troubleshooting

If you have any trouble using the AV receiver, look for a solution in this section. If you can’t resolve the issue your- self, contact your Onkyo dealer.

If you can’t resolve the issue yourself, try resetting the AV receiver before contacting your Onkyo dealer.

To reset the AV receiver to its factory defaults, turn it on and, while holding down VCR/DVR, press ON/ STANDBY. “Clear” will appear on the display and the AV receiver will enter Standby mode.

Note that resetting the AV receiver will delete your radio presets and custom settings.

Remote indicator

RECEIVER

AUDIO

To reset the remote controller to its factory defaults, while holding down RECEIVER, press and hold down AUDIO until the remote indicator lights (about 3 sec- onds). Within 30 seconds, press RECEIVER

again.

The on-screen setup menus appear only on a TV that is connected to the HDMI OUT. If your TV is con- nected to the MONITOR OUT V or the COMPO- NENT VIDEO OUT, use the AV receiver’s display when changing settings.

Power

■Can’t turn on the AV receiver

Make sure that the power cord is properly plugged — into the wall outlet.

Unplug the power cord from the wall outlet, wait five — seconds or more, then plug it in again.

■The STANDBY indicator flashes red

The protection circuitry has been activated.

—

Remove the power cord from the wall outlet immedi-

 

ately. Disconnect all speaker cables and input

 

sources, and then leave the AV receiver with its

 

power cord disconnected for 1 hour. After that,

 

reconnect the power cord and set the volume to max-

 

imum. If the AV receiver stays on, set then the vol-

 

ume to minimum, disconnect the power cord, and

 

reconnect your speakers and input sources. If the AV

 

receiver turns off when you set the volume to maxi-

 

mum, disconnect the power cord, and contact your

 

Onkyo dealer.

 

Audio

■There’s no sound, or it’s very quiet

Press SPEAKERS A or B to turn on the indicator

—

for the speakers that you want to output sound.

 

 

 

Make sure that the digital input source is selected

31

properly.

 

Make sure that all audio connecting plugs are pushed

15

in all the way.

 

 

 

Make sure that the inputs and outputs of all compo-

16-18

nents are connected properly.

 

Make sure that the polarity of the speaker cables is

12

correct, and that the bare wires are in contact with

 

the metal part of each speaker terminal.

 

 

 

Make sure that the input source is properly selected.

21

Make sure that the speaker cables are not shorting.

12

 

 

Check the volume. The AV receiver is designed for

—

home theater enjoyment. It has a wide volume range,

 

allowing precise adjustment.

 

If the MUTING indicator is flashing on the display,

22

press the remote controller’s MUTING to unmute

 

the AV receiver.

 

 

 

While a pair of headphones is connected to the

22

PHONES jack, no sound is output by the speakers.

 

If there’s no sound from a DVD player connected to

—

an HDMI IN, check the DVD player’s output set-

 

tings, and be sure to select a supported audio format.

 

 

 

Check the digital audio output setting on the con-

—

nected device. On some game consoles, such as

 

those that support DVD, the default setting is off.

 

With some DVD-Video discs, you need to select an

—

audio output format from a menu.

 

 

 

If your turntable uses an MC cartridge, you must

—

connect an MC head amp, or an MC transformer.

 

Make sure that none of the connecting cables are

—

bent, twisted, or damaged.

 

 

 

Not all listening modes use all speakers.

27

Specify the speaker distances and adjust the individ-

32

ual speaker levels.

 

 

 

The input signal format is set to PCM or DTS. Set it

39

to Auto.

 

 

 

En

47

Page 46 Page 48
Image 47
Page 46 Page 48
Contents HT-S3300 Away from the rear panel or wall, creating a flue-like Always consider the environmental issues and follow10 cm 4 at the rear. The rear edge of the shelf or Board above the apparatus shall be set 10 cmPrecautions Speaker Precautions Package Contents Contents SKR-380 L/R Full-Range Surround Speakers FeaturesAV Receiver HT-R380 Speaker Package HTP-380Front Panel Front & Rear PanelsFront Speakers B terminals UREMOTE Control jackDisplay Rear PanelKeyhole slots Speaker PackageSpeaker terminals Controlling the AV Receiver Remote ControllerEnjoying Home Theater About Home TheaterSpeakers a and B Connecting the Speaker Cables Connecting the AV ReceiverConnecting Your Speakers Speaker ConfigurationRight Wall Mounting Using the Rubber Stoppers for a More Stable PlatformUsing the Floor Pads for Subwoofer Hdmi cable About AV ConnectionsConnected image with AV components AV Cables and JacksAudio return channel ARC function Connecting Components with HdmiJack Signal Components Assignable How to record the video Connecting External ComponentsUsing the AUX Input jack on the front panel Remote Control Connecting Onkyo uComponentsConnecting Antenna System On/Auto Power OnVideo Connection Formats On-screen setup menus are displayed whenDepends on the Audio TV OUT setting Which Connections Should I Use?ON/STANDBY Turning On/Off the AV ReceiverTurning On Turning OffPress Music Optimizer on the front panel Using the Music OptimizerSetting the Display Brightness Displaying Source InformationChanging the Input Display Using the Sleep TimerUsing Headphones Muting the AV ReceiverListening to the Radio Using the TunerTuning into Radio Stations Listening to the RadioUsing RDS excluding North American models Presetting FM/AM StationsRDS program types PTY Finding Stations by Type PTYListening to Traffic News TP Recording Separate AV Sources Connecting a Recording ComponentRecording AV RecordingAbout Listening Modes Using the Listening ModesListening Mode Buttons Selecting Listening ModesDTS Listening ModesSpeaker Layout DSD*2 Onkyo-Original DSP Listening ModesCommon Procedures in Setup Menu Advanced SetupOn-screen Setup Menus Subwoofer Hdmi InputComponent Component Video Input Digital Audio Digital Audio InputSp Distance Speaker Distance Sp Config Speaker ConfigurationLevel Cal Level Calibration Audio AdjustMultiplex/Mono Settings Dolby SettingsAudyssey Settings DTS SettingName Edit Theater-Dimensional SettingRemote Control Settings FM/AM Frequency Setup SettingsHdmi Setup Speaker Levels Using the Audio SettingsTone Control Settings CinemaFILTER Late Night FunctionMusic Optimizer Sync Digital Input Signal FormatsAdjusting the Bass & Treble Audio SelectorOnkyo Dock Cable Connecting an Onkyo DockControlling iPod Models sold are different depending on the regionRI Dock Using the Onkyo DockUP-A1 Dock With the RI Control Controlling Your iPodWithout the RI Control Repeat Random Play ModeAvailable buttons 3, 2Controlling Other Components Preprogrammed Remote Control CodesEntering Remote Control Codes Remote Control Codes for Onkyo Components Connected via uControlling Other Components Resetting Remote Mode ButtonsResetting the Remote Controller You can reset the remote controller to its default settingsDisplay Muting Enter Setup Search Repeat Random Play ModeVCR/PVR ON/STANDBY Guide TOP MenuThere’s no sound, or it’s very quiet TroubleshootingStandby indicator flashes red Can’t turn on the AV receiverOnly the front speakers produce sound There’s no sound with a certain signal formatVolume cannot be set to About DTS signalsOn-screen menus don’t appear Remote controller doesn’t workAV receiver’s remote controller doesn’t control your iPod There’s no picture from a source connected to an HdmiUfunctions don’t work Sound changes when I connect my headphonesCan’t record How do I change the language of a multiplex sourceAV Receiver SpecificationsNorth American Center Speaker SKC-380 1ch Home Theater Speaker PackagePassive Subwoofer SKW-380 Asian Center Speaker SKC-380C Front Speaker SKF-380About Copyright Protection About HdmiSupported Audio Formats Operations that can be performed with p connection Using an RIHD-compatible TV, Player, or RecorderAbout p-compatible components Operate with the remote controller How to connect and setupConfirm the connecting and setting Confirm the settingsOnkyo China Limited Onkyo U.S.A. CorporationOnkyo Europe Electronics GmbH Onkyo Europe Electronics GmbH UK Branch

HT-S3300 specifications

The Onkyo HT-S3300 is a home theater system that brings immersive sound and cinematic experiences into the living room. This system combines a powerful AV receiver with a set of quality speakers designed to deliver vibrant audio across various media formats.

At the heart of the HT-S3300 is the Onkyo TX-SR313 AV receiver, which delivers a robust 5.1-channel surround sound performance. With a power output of 100 watts per channel, it ensures that every sound from subtle whispers to explosive action scenes is rendered with clarity and strength. The receiver supports multiple audio formats, including Dolby TrueHD and DTS-HD Master Audio, enhancing the experience of watching movies and playing video games.

One of the standout features of the HT-S3300 is its ease of use, made possible by the user-friendly Onkyo remote control and the intuitive graphical user interface. The system is designed to integrate seamlessly with various devices, making it a perfect choice for those who enjoy streaming content from different sources. The receiver is equipped with several HDMI inputs, allowing users to connect Blu-ray players, gaming consoles, and smartphones without hassle. Additionally, it is compatible with 3D video formats and supports 4K video pass-through for an ultra-high-definition viewing experience.

The speaker package that accompanies the HT-S3300 consists of a powerful subwoofer and five satellite speakers. The subwoofer enhances low-frequency sounds, producing deep bass that brings movie scenes to life. The satellite speakers are compact yet provide a balanced soundstage, allowing for an immersive surround sound experience. They can be easily mounted on walls or placed on shelves, making it convenient for different room layouts.

The Onkyo HT-S3300 also features advanced technologies such as Audyssey Room Correction. This technology analyzes the acoustics of the room and adjusts the sound settings accordingly, ensuring an optimal listening experience regardless of the room’s shape or size.

In conclusion, the Onkyo HT-S3300 is a versatile home theater system perfect for those seeking quality sound and flexibility. Whether you're a movie enthusiast or a gaming aficionado, the HT-S3300’s combination of power, features, and smart technologies makes it a strong contender in the home audio market. With the HT-S3300, transforming your living space into a dynamic entertainment hub has never been easier.
Top Page Image Contents