Vidikron Vision 20ET owner manual Troubleshooting, This unit does not turn

Page 45

English

Vidikron Owner’s Manual
7.	Insert the new lamp mod-	9.	Put on the lamp shield.
	ule into the projector hori-	10.	Tighten the three screws on
	zontally until it is securely	10.	Tighten the three screws on
	zontally until it is securely		the lamp shield.
	in place.		the lamp shield.
	in place.
8.	Tighen the two screws on
	the lamp module.
11.	Put on the front lamp cover.	13. Turn on the power and go into the Service menu, select
12.	Tighten the screw of front		Lamp Reset Timer item to reset lamp usage counter.
12.	Tighten the screw of front
	lamp cover.

Troubleshooting

Problem	Possible Cause	Remedy
	There is no power from power cable.	Plug the power cord into the AC inlet on the rear of this
		unit, and plug the power cord into to the power outlet.
This unit does not turn	The power switch is not turned on.	Turn on the power switch.
on.
on.	Turned on this unit again while still in the cool-	Wait until this unit completes the cooling down proce-
	ing down procedure.	dure.
	The front lamp cover is not correctly attached.	Correctly attach the front lamp cover.

44

Image 45

Contents Vision Model Vision Model 20ET Table of Contents Using the Menu Main Menu Picture Quality Adjustments Connecting Video InputsImage Options Image Option Projector Status Install ServiceRisk of Electric Shock English Two Year Limited Warranty RIGHTS, Limits and Exclusions Overview FeaturesVideo Memory PIP/ PBP functionFront / Upper Side Projector Exterior ViewFront Lamp Cover Control PanelRear / Bottom Side Control Panel Controls and FunctionsArrow c/e/d/f Zoom RingFocus Ring Connector Panel Arrow c,e,d,f Remote ControlWide IntelliWide PIP Picture in PicturePOP Picture On Picture Remote Control InstallationConnect the Power Cord Adjust the Lens Zoom/Focus ringProjector Adjust the height Ceiling Installation For Vision Model 20 With 1.71 2.06 LensScreen Hight Screen Width Min TD Max TD Vertical Offset Throw Distance Chart For Vision Model 20 With 1.71 2.06 LensCeiling Installation For Vision Model 20ET With 2.31 3.06 LensSWx2.31 SWx3.06 Screen Width x Connecting Connecting Video Inputs Video / S-Video / Component Interlaced VideoDVD Player DTV Source Progressive Component DTV Y/PB/PRRgbhv DTV RGB English Basic Operation Turning on the PowerSelecting Video Memory Zoom/ FocusingSelecting Input Source Setting MenuPIP/ POP function Selecting Aspect RatioTurning off the Power Menu Using the MenuPicture Adjust Picture Quality AdjustmentsProjector Status Install Service Main MenuInput Select Image OptionsScreens Aspect RatioMemory Store Image OptionPicture Adjust Image Options Install ServiceProjector Status Picture Configuration English Francais Espanol Deutsch ItalianoFloor Front Ceiling Front Floor Rear Ceiling Rear Blue Enable ServiceLamp Reset Timer White BalanceBlue Enable Reset Lamp TimerWhite Balance Blue Enable Replace the Lamp Contact your Vidikron Dealer Additional InformationThis unit does not turn TroubleshootingPower LED blinks Remote control doesNo picture Image is unstableVision Model 20/ Vision Model 20ET Specifications SpecificationsAnsi Lumen specification Dimensions RS-232C Control Codes RS-232 SetupSub 9-pin female PC Out Adapter