Zenith DXG-210 manual Using Your Zenith projector, Remote control

Page 7

5.Using Your Zenith projector

5.1Different program modes for your Zenith projector

The projector has the following modes of operation:

Stand-by mode

Normal mode

Quick mode

Menu mode

Pointer mode

Blank mode

Stand-by mode (see section 5.3)

In stand-by mode the projector is turned off and can be turned on by using defined keys.

Normal mode

In normal mode a picture will be shown on the screen.

Quick mode (see section 6.2.3)

Quick mode is used with the interactive remote control (quick key). You assign functionality for the quick key on the remote control in the quick menu (see section 6.2.3). When clicking on the Quick key you will be able to switch between all the functions you have selected in this menu.

Menu mode

In menu mode the menu system is activated and you use the mouse pad and the mouse but- tons on the remote control to navigate in the menu.

Pointer mode (see section 6.2.4)

In pointer mode you can move a pointer cursor on the screen by using the mouse function.

Blank mode (see section 6.2.4)

In blank mode the screen is blanked out (black).

5.2 Remote control

To access the Main Menu and control the varous image adjustments and utility functions of the projector

Point the remote control towards the projection screen. An infra-red beam bounces from the screen to an infra-red receiver on the projector.

Note!

Make sure nothing is blocking the IR receiver in front of projector located beside the lens, as this will prevent the communi- cation between the remote control and the projector.

To ensure smooth operation, the combined distance from the remote control to the screen and back to the projector should not exceed 33 feet (10 m). If the distance via the screen is longer, you should point the remote control directly towards the IR receiver.

 

MENU

ON

 

ZAP

QUICK

1

 

OFF

 

ZAP

 

2

Figure 9: Remote control

The Remote control is very easy to operate. It has only six keys in addition to the pressure sensing mouse pad.

The six keys are:

Key underneath the control

Left mouse key

Small gray key

Interrupt/break an action (right mouse key)

Menu

The menu key gives access to the menu control functions. To move within the various menu functions, position the arrow cursor by pressing the sensitive mouse pad and click with the left mouse button which is located underneath the remote control.

If you are in menu mode and press the menu key you will return to normal mode.

Zap

The two zap keys can be programmed to perform an assigned function. To assign a func- tion to the zap keys, select the Zap icon from the menu. The zap keys can be programmed to

do the same function e.g. volume up/down. See section 6.2.4 for further explanations of the zap menu.

Quick

When pressing the Quick key you can switch between all selected functions for the Quick key. See section 6.2.3. for how to select func- tions for the Quick key.

12

 

13

 

 

 

Image 7
Contents TheaterLite Risk of Electric Shock Do not Open Important Safety Instructions Contents Important information Before you startConnecting a video source to the projector Connecting a computer to the projectorRemote control Using Your Zenith projectorMenu system Using the menusUsing the touch panel on the projector Aspect Ratio SelectionSet-up menu Pointer LanguageQuick menu Zap menuPicture positioning Zoom/Focus adjustmentsControl panel menu Picture controlMaintenance Copyright 2001 Zenith Electronics Corporation