Remote Control MBR3470T, Battery Installation

REMOTE CONTROL

REMOTE CONTROL MBR3470T

The MBR3470T remote control is used specifically for servicing and setup adjustment. It provides the special functions needed for geometry, convergence, and system setup that other remotes cannot perform.

Red, Green, Blue Selects formats, sets Floor/Ceiling or a specific color convergence.

Vertical and Horizontal			Adjustment Select Keys
Adjusts selected			Adjusts selected
geometry/convergence			geometry/convergence
characteristics.			characteristics.

BATTERY INSTALLATION

Batteries are provided, but they must be installed before using the remote control. When it no longer functions normally, or when it loses memory, replace the batteries with two high-quality, alkaline, size AAA batteries.

To Install the Batteries

1.Open the battery compartment by pressing in on the tab and lifting the cover off.

2.Place the batteries into the compartment according to the markings shown in the compartment.

3.Replace the battery compartment cover.

Notes

•Do not place heavy objects on top of the remote control keys. Prolonged unintentional operation of the remote shortens the usable life of the batteries.

•Remove the batteries if the remote control will not be used for a month or more.

•The remote manufacturer is not responsible for damage caused by battery leakage.

CHOOSING THE SETUP FUNCTION

Press SETUP to set the remote control in “setup” mode. In the setup mode, you have the following choice of which setup functions to perform:

Geometry Convergence -- Press SETUP, then RED.

Single Color Convergence -- Press SETUP, then RED, and a color key (Red, Green or Blue) to select color to converge.

Forced Signal Formats -- Press SETUP, then GREEN.

Ceiling/Floor Select -- Press SETUP, then BLUE.

Red, Green, Blue

Setup

3276-A

P A G E 9