www.ti.com | TVP5158EVM Evaluation Procedures |
7 TVP5158EVM Evaluation Procedures
7.1
The following is the procedure for evaluation of TVP5158 for
1.
2.The VCC Configuration dialog box appears (see Figure 8). Click OK to continue.
3.The Cascaded Devices dialog box appears (see Figure 9). Click OK to continue. If a message appears indicating that the USB device was not found (see Figure 10), disconnect the USB cable, wait three seconds and reconnect the USB cable.
4.After 3 to 5 seconds, the
5.The VCC main window appears (see Figure 12).
6.Set video source(s) to the NTSC video standard (for this example).
7.Click the Tools > System Initialization menu item. The System Initialization dialog box (see Figure 13) appears. Click once on the following table entry:
TVP5158 + THS8200, NTSC,
Click the PROGRAM button. The TVP5158 is now programmed for the NTSC standard using the above video output format. The output formatter is bypassed.
8.To select a video input:
(a)In the VCC main window, select the video decoder for the video input to be displayed. This will select which source is used to detect the video standard for updating THS8200 register settings.
(b)In System Initialization table, click once on one of the following table entries to the select the video channel to be displayed and click the Program button.
Select
9.Video from the selected video input should now be seen on the monitor and audio channels 1 and 2 should be heard from the left and right speakers respectively.
Figure 8. VCC Configuration
SLEU108 | TVP5158 Evaluation Module | 17 |
Submit Documentation Feedback |
|
|
Copyright © 2009, Texas Instruments Incorporated