VCC Software in Depth | www.ti.com |
8.4.4Editing Tools vs Video Decoder Write Enables
The behavior of the System Initialization, Edit Register Map and Property Sheets tools regarding the decoder write enables is described in Table 12.
Figure 19. VCC Main Window – Configured for Broadcast Write Access (default)
Figure 20. VCC Main Window – Configured for Single Video Decoder Write Access
Table 12. Editing Tools vs Video Decoder Write Enables
Editing Tool | Reads From | Writes To | Writes What |
|
|
|
|
Command File | N/A | Write Enabled decoders | I2C register values |
|
| (can be overridden in cmd file) |
|
|
|
|
|
Edit Register Map | Selected Decoder | Write Enabled decoders | 1 byte – same data to all |
|
|
|
|
Edit Property Sheets | Selected Decoder | Write Enabled decoders | Bit fields that changed on the selected |
|
|
| decoder |
|
|
|
|
8.5Example TVP5158 Property Pages
Example property pages are shown in Figure 21 through Figure 24.
Some of the controls for the Output Formatter (OFM) page only exist for video decoder 1. Figure 21 shows the OFM page when Decoder 1 is the selected decoder. Figure 22 shows the OFM page when Decoder 4 is the selected decoder (some of the OFM controls are not visible). They would also not be visible for Decoder 2 and Decoder 3. To change the Port A selection, for example, Decoder 1 must be the selected decoder.
The Audio property page only exists for video decoder 1. To access the Audio controls Decoder 1 must be the selected decoder.
28 | TVP5158 Evaluation Module | SLEU108 |
|
| Submit Documentation Feedback |
Copyright © 2009, Texas Instruments Incorporated