www.ti.comTroubleshooting
Table 15. Troubleshooting with DM6467 DaVinci HD EVM
Symptom | Cause | Solution |
|
|
|
No serial communication | Wrong serial port | Set terminal program to 115200 baud, 8 bit data, no parity, 1 stop bit. Check |
| settings | that COM port is available in the Windows Device Manager and is not being |
|
| used by another program. |
|
|
|
| Wrong cable type | Use a null MODEM |
|
| wired to pins 3 and 2 at the other end. |
|
|
|
Boot up process fails | No wired network | Connect Ethernet LAN cable to DaVinci HD EVM |
| connection |
|
|
|
|
| No FTP server available | Boot up arguments must specify the IP address of the computer that contains |
|
| the image file to be loaded. An FTP server program must be runnning on that |
|
| computer. |
|
|
|
| No Linux host available | A PC running the Linux O/S or a PC running the Windows O/S with a virtual |
|
| Linux O/S must be accessible on the LAN and provide a shared file system |
|
| for the boot process. |
|
|
|
Table 16. Troubleshooting I2C Connections and Cascaded EVMs
Symptom | Cause | Solution | |
|
|
| |
When PC USB (VCC application) is I2C master for TVP5158 | |||
|
|
| |
USB: I2C Error Code 1 | I2C bus master | Check that jumpers W3 and W4 are connected across pins | |
error message. | jumpered incorrectly. | as I2C master. | |
|
|
| |
When DSP video/audio driver is I2C master for TVP5158 | |||
|
|
| |
I2C error messages | I2C bus master | Check that jumpers W3 and W4 are connected across pins | |
from demo application. | jumpered incorrectly. | DaVinci HD EVM as I2C master. | |
|
|
| |
When cascading two TVP5158EVMs together |
| ||
|
|
| |
I2C error messages | I2C bus master | The Stage 2 TVP5158EVM feeds cascaded video and audio data through | |
from demo application. | jumpered incorrectly. | ||
connector J2 to connector J3 of the Stage 1 TVP5158EVM. | |||
|
| ||
|
| On the Stage 2 board, check that jumpers W2, W1, and W0 are connected | |
|
| across pins | |
|
| 0xB2. | |
|
| On the Stage 2 board, check that jumpers W3 and W4 are both removed to | |
|
| allow I2C to be mastered by the stage 1 board. | |
|
| Also on the Stage 2 board, remove W7 and W8 to remove the second Audio | |
|
| DAC from the I2C bus. | |
|
| The Stage 1 TVP5158EVM can have I2C controlled by USB or the DaVinci | |
|
| HD EVM. | |
|
| Any changes to the above setup require that VCC be exited and restarted so | |
|
| that the correct I2C slave address(es) can be selected. | |
|
|
|
SLEU108 | TVP5158 Evaluation Module 35 |
Submit Documentation Feedback |
|
Copyright © 2009, Texas Instruments Incorporated