Texas Instruments TVP5154EVM manual TVP5154 Property Sheets, Memory Map Editor Controls

www.ti.com

	WinVCC in Depth
	Table 5. Memory Map Editor Controls
CONTROL	DEFINITION
Base Address Selector	The hardware registers use a 10-bit address internally. The base address selector allows quick entry
	of the base address. The list contains base addresses for the major functional blocks of the
	TVP5154.
Address Offset Edit Box	Contains the lowest byte of the 10-bit internal address. The full 10-bit address is formed by adding
	the base address to the address offset. The address up/down arrows increment/decrement the
	address offset by 1.
Data Edit Boxes	Contains the 16-bit data word that is written to or read from the register address. The LSB data is at
	the lowest address. The data is written/read LSB first. The data up/down arrows
	increment/decrement the data value by 1.
Write Button	Writes the (2) bytes in the data edit boxes starting at the 10-bit register address BASE+OFFSET.
Read Button	Reads (2) consecutive data bytes starting at the 10-bit register address BASE+OFFSET to the data
	edit boxes.
Loop Count Edit Box	Causes subsequent write or read operations to be performed N times. N is entered as a decimal
	number from 1 to 999.
Histogram on	Creates a histogram of the results from the Loop Count Reads.
Loop Count Reads
Close Button	Closes the dialog.
	Note: The memory map editor can remain open with other
	windows. Use the Window menu to navigate.

8.6TVP5154 Property Sheets

The property sheets represent the register data in a user-friendly format. The data is organized by function, with each function having its own page and being selectable via tabs at the top (see Figure 20).

To open this, click on Edit Property Sheets in the Edit menu and select the device type to edit.

When the property sheet function is started or whenever the user tabs to a different page, all readable registers in the device are read from hardware to initialize the dialog pages. Values on the page are changed by manipulating the various dialog controls as described in Table 6.

OK, Cancel, and Apply buttons are at the bottom of each property page. These are described in Table 7.

SLEU069A –February 2006 –Revised July 2006 TVP5154EVM User's Guide 23

Submit Documentation Feedback