Texas Instruments TVP5154EVM Test Points and Jumpers, Power-Down-Mode Selection Jumper PDN, JP11

www.ti.com

Board Level Description

2Board Level Description

The TVP5154EVM consists of the TVP5154EVM module and the encoder EVM module. A 4-row 120-pin connector connects the boards. The block diagram of the EVM set is shown in Figure 1.

Figure 1. TVP5154EVM Block Diagram

2.1Test Points and Jumpers

The TVP5154EVM was designed with test points and jumpers to help in evaluation and troubleshooting. Each jumper is set by default in its preferred state for the TVP5154EVM. There are test points for SCL,

SDA, 3.3 V, and 1.8 V. All digital video data for each decoder core are brought out to a dual-row header, which allows easy hookup to test equipment. The I2C address selection is made with two shunt jumpers, which are only read after a reset or at power up. The default address is 0xB8. If the address needs to be changed, the TVP5154 must receive a reset.

Table 1. I2C Address Selection Jumpers

(I2CSEL1, JP9 and I2CSEL2, JP10)

JP9	JP10	I2C ADDRESS
2-3	2-3	0xB8
1-2	2-3	0xBA
2-3	1-2	0xBC
1-0	1-2	0xBE

Table 2. Power-Down-Mode Selection Jumper

(PDN, JP11)

	PWDN
1-2	Normal operation
2-3	Power down

SLEU069A –February 2006 –Revised July 2006 TVP5154EVM User's Guide 7

Submit Documentation Feedback