Onkyo TX-DS898 instruction manual Preference, Headphones Level Setup sub-menu, OSD Setup sub-menu

Page 45

Preference

4-2. Headphones Level Setup sub-menu

You can use this sub-menu to adjust the volume output from the headphones so that it matches the level output from the speakers. The headphone volume can be adjusted between –12 and +12 decibels.

Advanced Menu

4.Preference

4-2.HeadphoneLevel Setup

a.Headphones Level

: 0dB

Quit:SETUP

4-3. OSD Setup sub-menu

This sub-menu allows you to customize the OSD Setup menu to display in the manner you desire.

Advanced Menu

4.Preference

4-3.OSD Setup

a.Background Color

:Blue1

b.Superimpose Mode

:Normal

c.Immediate Display

:On

d.Display Position

:Bottom

Quit:SETUP

a. Background Color

Select either Blue1, Blue2, Green1, Green2, Magenta, Red1, or Red2 as the background color while the OSD Setup menu is displayed.

b. Superimpose

Off: Select to have the OSD Setup menu displayed on the selected background color.

Normal: Select to have the OSD Setup menu superimposed over the current video if one is displayed or on the selected background color if there is no video signal.

Black: Select to have the OSD Setup menu displayed on a black background at all times.

c. Immediate Display

On: Select this to have the screen immediately display certain operations as you perform them. The display will remain for a few seconds after the operation is completed.

Off: Select this to turn off the immediate display of operations.

VIDEO 1

Hint:

If this is set to “Off,” the background color will not be displayed even when there is no video signal input.

d. Display Position

Use this setting to select the position of the immediate display that appears when certain operations are performed. You can position the immediate display at any of ten different levels ranging from the top all the way to the bottom.

4-4. OSD Position sub-menu

This sub-menu allows you to adjust the position of the OSD Setup menu as it is displayed on your screen. Depending on the monitor used, there may be cases where the OSD Setup menu is not displayed in the center and parts of the menus are cut off. To adjust the position of the OSD Setup menu, simply press the cursor buttons to inch the menu to position you desire.

Advanced Menu

4.Preference

4-4.OSD Position

Exit:RETURN

45

Image 45

Contents TX-DS898 Avis Important SafeguardsPrecautions Contents Contents Supplied accessories FeaturesBefore using this unit Installing the remote controller batteriesUsing the remote controller Front panel Front panel facilitiesFront door Front panel displayFront panel facilities Remote controller Remote controller Digital INPUT/OUTPUT coaxial and optical Rear panel facilities3 4 Rear panel facilitiesVideo IN/OUT IR IN/OUTMulti Channel Input GNDConnecting a turntable PH Connecting your audio componentsConnecting a compact disc player CD ConnectionsFlow of the video signals is as follows Connecting your video componentsConnecting a DVD player DVD ConnectionsConnecting a video cassette recorder Video Connecting a television monitor or projector Connecting video camera, etc. VideoIdeal speaker configuration Connecting speakersMinimum speaker configuration for surround sound playback Speaker placementConnecting speakers Connecting speakersConnecting the speaker cable Connecting a subwooferWhen using the Surr BACK/ZONE 2 Speakers terminals Connecting the remote zone Zone 2 speakersWhen using the Zone 2 OUT terminals When using the Surr BACK/ZONE 2 PRE OUT terminalsFrom connecting block Connecting the included antennas Connecting antennasConnecting the AM antenna cable Assembling the AM loop antennaConnecting an FM outdoor antenna Connecting antennasConnecting an AM outdoor antenna Directional linkagePower Connecting the powerSTANDBY/ON Stdby RcvrSetup menus Basic MenuAdvanced Menu Setup menus Navigating through the Setup menuPress the Setup button Hardware Setup menu Hardware SetupIR in Setup sub-menu Speaker Impedance sub-menuSpeaker Setup Speaker Setup menuSpeaker Config sub-menu Speaker Distance sub-menu Speaker SetupCalibrating the speaker levels Level Calibration sub-menuLeft RightBass Peak Level Bass Peak Level Manager* sub-menu Bass Peak Level LimiterPeak Level Input Setup menu Input SetupDigital Setup sub-menu Initial settings for each input sourceMultichannel Setup sub-menu Input SetupDigital Input Digital FormatLast Valid enables the source last selected The source that Video Setup sub-menuVideo Component VideoIntelli Volume Intelli Volume sub-menuCharacter Input sub-menu Character DisplayRelationship between input source and listening mode Listening Mode Preset sub-menuListening Modes Input source signalsDTS-ES Discrete DTS Neo6DTS-ES Matrix THX CinemaAudio Adjust Setup menu Audio AdjustAudio Adjust Surr Mode Analog/PCM Surround SetupSurr Mode D.F.2ch Pro Logic II Music DimensionDecoder THX SetupTHX Surround EX Dolby D Front EffectVolume Setup sub-menu PreferencePreference menu OSD Setup sub-menu Headphones Level Setup sub-menuPreference OSD Position sub-menuTuning into a radio station Listening to a stereo radio station FM modeListening to Radio Broadcasts Erasing a preset radio station Presetting a radio station Selecting a preset radio stationListening to Radio Broadcasts Memory EnterListening with headphones Adjusting the bass and trebleEnjoying music or videos with the TX-DS898 Temporarily turning off the soundEntering characters using the TX-DS898 Changing the listening modeDirect Setup Pure Audio Enter Return Enjoying music or videos with the TX-DS898Adjusting the brightness of the front display Switching the displayUsing the sleep time remote controller only Temporarily changing the speaker output levelsEnjoying the multichannel output Changing the audio modeSelecting an input source using the remote controller Playing music using the buttons on the TX-DS898Adjusting the volume for the remote zone Enjoying music in the remote zoneRecording a source REC OUTStart recording at the recording component as desired Recording a source Calling up a preset radio station Using remote controllerOverview Controlling an Onkyo cassette tape deckDisc Stdby CD Mode Using remote controllerPress the CD Mode button Controlling an Onkyo CD playerControlling an Onkyo DVD player On Stdby MD Mode SAT, CABLE, VCR, and TV Mode buttonsPress the MD Mode button Controlling an Onkyo MD recorderLearning a pre-programming code When entering the code of Onkyo DVD playersLearning a pre-programming code DisplayPre-programming codes Learning a pre-programming codeDVD CableDVD Mode DVD Player Mode Operating your programmed remote controllerSAT Mode Satellite Tuner Mode Cable Mode Cable ModeVCR Mode VCR Mode Operating your programmed remote controllerTV Mode TV Mode On Stdby VCR Mode VOL TV/VCR MutingLight Direct Mode Macro Macro Programming procedurePage Erasing all the commands programmed under a Mode button Erasing the programmed command from one buttonPress and release the same Mode button again Press and release the same button againWhat is a Macro function? Using a Macro functionMode Macro Programming a Macro functionRcvr CD Mode Using a Macro functionProgramming the Direct Macro function Running a Direct Macro functionPress the Mode Macro button again Erasing a macro from the Mode Macro buttonErasing a direct macro from the Direct Macro button Direct MacroMacro mode programming memo Erasing all commands and macros that have been programmedOn Stdby Enter Press the Enter buttonTroubleshooting guide Troubleshooting guide Video and AudioIf one of the messages shown below appears Amplifier Section Specifications