Onkyo TX-DS898 instruction manual Specifications, Amplifier Section

Page 72

Specifications

AMPLIFIER SECTION

Continuous Average Power output (FTC)

All channels:

110 watts per channel min. RMS at

 

8 ohms, 2 channels driven from 20

 

Hz to 20 kHz with no more than

 

0.08% total harmonic distortion.

 

145 watts min. RMS at 6 ohms, 2

 

channels driven from 1 kHz with

 

no more than 0.1% total harmonic

 

distortion.

Continuous Power output (DIN)

150 watts at 6 ohms

Maximum Power output (EIAJ)

180 watts at 6 ohms

Dynamic Power Output (Stereo)

2 × 280 watts at 3 ohms

 

2 × 220 watts at 4 ohms

 

2 × 140 watts at 8 ohms

Total Harmonic Distortion:

0.08% at rated power

 

0.08% at 1 Watt output

IM Distortion:

0.08% at rated power

 

0.08% at 1 Watt output

Damping Factor:

60 at 8 ohms

Input Sensitivity and Impedance

 

PHONO:

2.5 mV, 50 kohms

LINE (CD, TAPE, DVD,

 

VIDEO 1-5):

200 mV, 50 kohms

MULTICHANNEL INPUT

 

(FRONT L/C/R, SURROUND

 

L/R, SURROUND BACK L/R):

200 mV, 50 kohms

(SUBWOOFER):

36 mV, 50 kohms

COAXIAL 1, 2, 3 (DIGITAL):

0.5 Vp-p, 75 ohms

DVD, VIDEO 1, 2, 3, 4, 5:

1 Vp-p, 75 ohms

 

1 Vp-p, 75 ohms (Y)

 

0.28 Vp-p, 75 ohms (C)

COMPONENT VIDEO 1, 2:

1 Vp-p, 75 ohms (Y)

 

0.7 Vp-p, 75 ohms (PB, PR)

Output Level and Impedance

 

Rec out (TAPE, VIDEO 1, 2):

 

 

200 mV, 470 ohms

Pre out:

1 V, 470 ohms

ZONE 2 OUT:

100mV, 470 ohms

VIDEO (VIDEO 1, 2, MONITOR

OUT, ZONE 2 OUT):

1 Vp-p, 75 ohms

 

1 Vp-p, 75 ohms (Y)

 

0.28 p-p, 75 ohms (C)

COMPONENT VIDEO OUT:

1 Vp-p, 75 ohms (Y)

 

0.7 Vp-p, 75 ohms (PB, PR)

Phono Overload:

120 mV RMS at 1 kHz, 0.5% T.H.D.

Frequency Response:

10 Hz to 100 kHz : +1/–3 dB

 

(CD in Direct mode)

RIAA Deviation:

20 Hz to 20 kHz : ±0.8 dB

Tone Control

 

Bass:

±10 dB at 50 Hz

Treble:

±10 dB at 20,000 Hz

Signal-to-Noise Ratio (Stereo)

 

Phono:

80 dB (IHF A, 5 mV input)

CD/Tape:

110 dB (IHF A, 0.5 V input)

TUNER SECTION

 

FM

 

Tuning Range:

87.5 — 108.0 MHz (50 kHz steps)

Usable Sensitivity

 

Mono:

11.2 dBf, 1.0 µV (75 ohms IHF)

 

0.9 µV (75 ohms DIN)

Stereo:

17.2 dBf, 2.0 µV (75 ohms IHF)

 

23 µV (75 ohms DIN)

50 dB Quieting Sensitivity

 

Mono:

17.2 dBf, 2.0 µV (75 ohms)

Stereo:

37.2 dBf, 20 µV (75 ohms)

Capture Ratio:

2.0 dB

Image Rejection Ratio

40 dB

IF Rejection Ratio:

90 dB

Signal-to-Noise Ratio

 

Mono:

76 dB

Stereo:

70 dB

Alternate Channel Attenuation:

55 dB

Selectivity:

50 dB (DIN)

AM Suppression Ratio:

50 dB

Total Harmonic Distortion

 

Mono:

0.2%

Stereo:

0.3%

Frequency Response:

30 Hz — 15 kHz, ±1.0 dB

Stereo Separation:

45 dB at 1 kHz

AM

30 dB at 100 Hz — 10 kHz

 

Tuning Range:

530—1,710 kHz (10 kHz steps)

Usable Sensitivity:

30 µV

Image Rejection Ratio:

40 dB

IF Rejection Ratio:

40 dB

Signal-to-Noise Ratio:

40 dB

Total Harmonic Distortion:

0.7%

GENERAL

 

Power Supply:

AC 120 V, 60 Hz

Power Consumption:

7.8 A

Dimensions (W × H × D):

17-1/8" × 6-7/8" × 18-1/16"

Weight:

38.4 lbs.

REMOTE CONTROLLER

 

Transmitter:

Infrared

Signal range:

Approx. 5 meters, 16 ft.

Power supply:

Two “AA” batteries (1.5 V × 2)

Specifications and features are subject to change without notice.

Sales & Product Planning Div. : 2-1, Nisshin-cho, Neyagawa-shi, OSAKA 572-8540, JAPAN

Tel: 072-831-8111 Fax: 072-833-5222 http://www.onkyo-intl.com

ONKYO U.S.A. CORPORATION

18 Park Way, Upper Saddle River, N.J. 07458, U.S.A.

Tel: 201-785-2600 Fax: 201-785-2650 http://www.onkyousa.com

ONKYO EUROPE ELECTRONICS GmbH

Liegnitzerstrasse 6, 82194 Groebenzell, GERMANY

Tel: +49-8142-4401-0 Fax: +49-8142-4401-555 http://www.onkyo.net

ONKYO CHINA LIMITED

 

 

 

 

 

Units 2102-2107, Metroplaza Tower I, 223 Hing Fong Road, Kwai Chung,

HOMEPAGE

N.T., HONG KONG Tel: 852-2429-3118 Fax: 852-2428-9039 http://www.onkyochina.com

http://www.onkyo.co.jp/

 

 

 

 

SN 29343172A

D0108-2

 

E

 

 

 

 

Page 71 Page 72
Image 72
Page 71 Page 72
Contents TX-DS898 Important Safeguards AvisPrecautions Contents Contents Features Supplied accessoriesBefore using this unit Installing the remote controller batteriesUsing the remote controller Front panel facilities Front panelFront door Front panel displayFront panel facilities Remote controller Remote controller Rear panel facilities Digital INPUT/OUTPUT coaxial and opticalRear panel facilities 3 4IR IN/OUT Video IN/OUTMulti Channel Input GNDConnecting your audio components Connecting a turntable PHConnecting a compact disc player CD ConnectionsConnecting your video components Flow of the video signals is as followsConnecting a DVD player DVD ConnectionsConnecting a video cassette recorder Video Connecting video camera, etc. Video Connecting a television monitor or projectorConnecting speakers Ideal speaker configurationMinimum speaker configuration for surround sound playback Speaker placementConnecting speakers Connecting speakersConnecting the speaker cable Connecting a subwooferConnecting the remote zone Zone 2 speakers When using the Surr BACK/ZONE 2 Speakers terminalsWhen using the Zone 2 OUT terminals When using the Surr BACK/ZONE 2 PRE OUT terminalsFrom connecting block Connecting antennas Connecting the included antennasConnecting the AM antenna cable Assembling the AM loop antennaConnecting antennas Connecting an FM outdoor antennaConnecting an AM outdoor antenna Directional linkageConnecting the power PowerSTANDBY/ON Stdby RcvrSetup menus Basic MenuAdvanced Menu Setup menus Navigating through the Setup menuPress the Setup button Hardware Setup Hardware Setup menuIR in Setup sub-menu Speaker Impedance sub-menuSpeaker Setup Speaker Setup menuSpeaker Config sub-menu Speaker Setup Speaker Distance sub-menuLevel Calibration sub-menu Calibrating the speaker levelsLeft RightBass Peak Level Bass Peak Level Manager* sub-menu Bass Peak Level LimiterPeak Level Input Setup Input Setup menuDigital Setup sub-menu Initial settings for each input sourceInput Setup Multichannel Setup sub-menuDigital Input Digital FormatVideo Setup sub-menu Last Valid enables the source last selected The source thatVideo Component VideoIntelli Volume sub-menu Intelli VolumeCharacter Input sub-menu Character DisplayListening Mode Preset sub-menu Relationship between input source and listening modeInput source signals Listening ModesDTS Neo6 DTS-ES DiscreteDTS-ES Matrix THX CinemaAudio Adjust Audio Adjust Setup menuAudio Adjust Surround Setup Surr Mode Analog/PCMSurr Mode D.F.2ch Pro Logic II Music DimensionTHX Setup DecoderTHX Surround EX Dolby D Front EffectVolume Setup sub-menu PreferencePreference menu Headphones Level Setup sub-menu OSD Setup sub-menuPreference OSD Position sub-menuTuning into a radio station Listening to a stereo radio station FM modeListening to Radio Broadcasts Presetting a radio station Selecting a preset radio station Erasing a preset radio stationListening to Radio Broadcasts Memory EnterAdjusting the bass and treble Listening with headphonesEnjoying music or videos with the TX-DS898 Temporarily turning off the soundChanging the listening mode Entering characters using the TX-DS898Direct Setup Pure Audio Enter Return Enjoying music or videos with the TX-DS898Switching the display Adjusting the brightness of the front displayUsing the sleep time remote controller only Temporarily changing the speaker output levelsChanging the audio mode Enjoying the multichannel outputPlaying music using the buttons on the TX-DS898 Selecting an input source using the remote controllerAdjusting the volume for the remote zone Enjoying music in the remote zoneRecording a source REC OUTStart recording at the recording component as desired Recording a source Using remote controller Calling up a preset radio stationOverview Controlling an Onkyo cassette tape deckUsing remote controller Disc Stdby CD ModePress the CD Mode button Controlling an Onkyo CD playerControlling an Onkyo DVD player SAT, CABLE, VCR, and TV Mode buttons On Stdby MD ModePress the MD Mode button Controlling an Onkyo MD recorderWhen entering the code of Onkyo DVD players Learning a pre-programming codeLearning a pre-programming code DisplayLearning a pre-programming code Pre-programming codesDVD CableOperating your programmed remote controller DVD Mode DVD Player ModeSAT Mode Satellite Tuner Mode Cable Mode Cable ModeOperating your programmed remote controller VCR Mode VCR ModeTV Mode TV Mode On Stdby VCR Mode VOL TV/VCR MutingProgramming procedure Light Direct Mode Macro MacroPage Erasing the programmed command from one button Erasing all the commands programmed under a Mode buttonPress and release the same Mode button again Press and release the same button againUsing a Macro function What is a Macro function?Mode Macro Programming a Macro functionUsing a Macro function Rcvr CD ModeProgramming the Direct Macro function Running a Direct Macro functionErasing a macro from the Mode Macro button Press the Mode Macro button againErasing a direct macro from the Direct Macro button Direct MacroErasing all commands and macros that have been programmed Macro mode programming memoOn Stdby Enter Press the Enter buttonTroubleshooting guide Troubleshooting guide Video and AudioIf one of the messages shown below appears Specifications Amplifier Section
Top Page Image Contents