Onkyo TX-DS898 Hardware Setup menu, IR in Setup sub-menu, Speaker Impedance sub-menu

Hardware Setup

0. Hardware Setup menu

Advanced Menu

0.Hardware Setup

1.Speaker Impedance 2.IR IN Setup

ENTERQuit:SETUP

0-2. IR IN Setup sub-menu

Advanced Menu

0.Hardware Setup

0-2.IR IN Setup
a.Position	:Main
	Quit:SETUP

The Hardware Setup menu will need to be set before you use your TX-DS898 for the first time. Once you set the Speaker Impedance setting at the Hardware Setup menu, the setting will not be displayed again when you enter the Basic Menu. To change the setting at a later date, select the Advanced Menu to display the Hardware Setup menu.

0-1. Speaker Impedance sub-menu

Set the impedance level to match the specifications of the speakers you are using.

If the impedances of all speakers are between 6 and 16 Ω, select “6 ohms.” If the impedance of even one speaker is between 4 and 6 Ω, select “4 ohms.”

Note:

Before you change this setting, be sure to first lower the volume at the TX-DS898 to the minimum level.

Advanced Menu

0.Hardware Setup

0-1.Speaker Impedance

a.Minimum :6 ohms

Quit:SETUP

This sub-menu allows you to set where you will be using the remote controller when you are using it in conjunction with the IR IN terminal (i.e. remote controller signals are input at the IR IN terminal).

Main: Select when you have a remote sensor for the remote controller connected to the IR IN terminal in the main room.

Zone 2: Select to perform the remote zone (Zone 2) operations from the remote zone. When this is selected, the ON/STDBY, INPUT

SELECTOR, CH , and LEVEL / (or VOL ) buttons work without having to press the ZONE 2 button on the remote controller.

28