Zenith Data Systems MT2000 Press F1 to resume, F2 to Setup, Press F2 to enter Setup, Run Setup

Models: MT2000

1 205
Download 205 pages 62.34 Kb
Page 162
Image 162

 

6-19

Table 6-2. BIOS Messages (Continued)

 

 

MESSAGE

DESCRIPTION

 

 

Press <F1> to resume, <F2> to Setup

Displayed after any recoverable error message.

Press <F2> to enter SETUP

Optional message displayed during POST. Can be turned off

 

in Setup.

Previous boot incomplete - Default

Previous POST did not successfully complete. POST loads

configuration used

default values and offers to run Setup. If the failure was

 

caused by incorrect values and they are not corrected, the

 

next boot will likely fail. On systems with control of wait

 

states, improper Setup settings can also terminate POST

 

and cause this error on the next boot. Run Setup and verify

 

that the wait-state configuration is correct. This error is

 

cleared the next time the system is booted.

Real time clock error*

Real time clock fails BIOS test. May require board repair.

Shadow Ram Failed at offset: nnnn*

Shadow RAM failed at offset nnnn of the 64K block at which

 

the error was detected.

nnnn Shadow RAM Passed

Where nnnn is the amount of shadow RAM in kilobytes

 

successfully tested.

System battery is dead - Replace and

The CMOS clock battery indicator shows the battery is dead.

run SETUP

Replace the battery and run Setup to reconfigure the

 

system.

System BIOS shadowed

The system BIOS is copied to shadow RAM.

System cache error - Cache disabled*

The RAM cache failed the BIOS test and BIOS has disabled

 

the cache.

System CMOS checksum bad - run

The system CMOS has been corrupted or incorrectly

SETUP

modified, perhaps by an application program that changes

 

data stored in CMOS. Run Setup and reconfigure the

 

system either by getting the default values or making your

 

own selections.

System RAM failed at offset: nnnn*

The system RAM failed at offset nnnn of the 64K block at

 

which the error was detected.

nnnn System RAM Passed

Where nnnn is the amount of system RAM in kilobytes

 

successfully tested.

System timer error*

The timer test failed. Requires repair of the system board.

UMB upper limit segment address:

Displays the address nnnn of the upper limit of the Upper

nnnn

Memory Blocks, indicating released segments of the BIOS

 

which may be reclaimed by a virtual memory manager.

Video BIOS shadowed

The video BIOS is successfully copied to shadow RAM.

*If your system displays this message, write down the message and notify your customer representative. If your system fails after you made changes in the BIOS Setup menus, you may be able to correct the problem by entering Setup and restoring the original values.

Problem Solving

Page 162
Image 162
Zenith Data Systems MT2000 Press F1 to resume, F2 to Setup, Press F2 to enter Setup, Previous boot incomplete Default