5.Carefully pull out on the thumbscrew until the middle and the top of the front cover are released, then remove it from the chassis by pulling it straight up and out of the hinge tabs at the bottom edge of the cover.
Figure 5-17. Removing Front Plastic Cover
B
POWER
RESET
POWER
STATUS
DISK
A
Removing front plastic cover from media and diskette drive bays
AThumbscrew that secures the front plastic cover to the front of the chassis
BFour
CTwo frame hinge tabs
C
6.Place the frame face down on a soft surface to prevent marring it.
7.From the bay where you want to install a drive, remove the two screws securing the blank panel tray to the chassis (Figure
