Zenith Data Systems MT2000 manual Configuring I/O Riser Board Function Select Switches

4-25

Configuring I/O Riser Board Function Select Switches

This section describes how to configure and set the function select switches for specific operating parameters.

Caution: Before doing the procedures in this section, make sure that your system is powered off and unplug the AC power cord from the back of the chassis. Failure to disconnect power before setting switches and moving jumpers can result in personal injury and equipment damage.

The function select DIP switches configure the modes of your server. Figure 4-1 shows the DIP switches that consist of a block of four switches, accessible on the I/O panel that is located on the I/O riser board at the rear of the chassis.

Figure 4-1. Function Select Switches and Dump Button

A

B

1 2 3 4

ON DIP

AFunction select switches

BDump button

Configuring Your System