Zenith Data Systems MT2000 manual Function Select Switch Settings, Switch Signal Settings Function

4-26

Situations that require changing switch settings include the following.

■using an uninterruptible power supply

Note: The switches are set correctly at the factory for your system configuration. If your system requires a switch change, change only the switch setting for that condition. Otherwise keep the switches at their factory settings.

Table 4-7 shows the switch configurations and functions. Set the switches per Table 4-7 and the following steps.

Table 4-7 Function Select Switch Settings

Switch	Signal	Settings	Function
SW1	RESERVED	Off (factory setting)	Reserved for future use.
		On
SW2	RSTMASK	Off	Reserved for future use.
		On (factory setting)
SW3	ACLINK	Off (factory setting)	Sets server for use with a local power source.
		On	Sets server for use with an optional
			uninterruptible power supply (UPS) unit and
			disables the Power button on the front of the
			server.
SW4	RESERVED	Off (factory setting)	Reserved for future use.
		On

To change a switch setting, use the following procedure.

Note: Power must be completely off before setting the switches, otherwise the settings will not be recognized.

1.At the front of the server, press the Power switch off.

2.At the rear of the server, press the Main Power switch off.

Configuring Your System