Characters are Distorted or Incorrect
Check the following:
■Are the brightness and contrast controls properly adjusted on the video display? Refer to the documentation supplied with your video display.
■Are the video display signal and power cables properly installed?
■Is the SCU configuration set up correctly for the type of monitor you have attached to the system?
■If the problem persists, the video display may be faulty or it may be the incorrect type. Contact your service representative for assistance.
Incorrect Or No Beep Code
Check the following:
■Is the speaker enabled?
■Is the speaker cable connected to the system board?
If the system operates normally, but there was no beep, the speaker may be defective, contact your service representative for assistance.
Record the beep code emitted by POST and refer to the Error Messages section, for information about beep pattern error messages.
