Zenith Data Systems MT2000 manual Replacing the Non Volatile Memory

5-22

Figure 5-8. Non-Volatile Memory Location

Replacing the Non - Volatile Memory

Notice: Observe static precautions. Use an antistatic wrist strap.

1.Power off the system and remove the side panel as described earlier in this chapter.

2.Using a IC removal tool or a small pointed tool, gently pry up each end of the non-volatile memory and pull it straight up out of its socket (Figure 5-8).

3.Orient the new chip over its socket so the dot is properly oriented. Carefully insert the chip into its socket connectors.

4.Press down on the chip until it is firmly seated in its socket.

5.Replace the side panel and turn on the system.

6.Run the BIOS SETUP and SCU to restore proper configuration settings.

Upgrades and Options