ISA Board Configuration
If you want to add an ISA board to your system that is not included in a .cfg file, use the following procedures to define and add the option board. It is necessary to define an ISA board to prevent other boards in the system from using the same IRQ levels, DMA channels, I/O port addresses, or memory addresses, that your ISA board uses. Standard ISA board options have .cfg files already on your SCU diskette.
You must run the SCU and add the ISA board to the configuration before installing the ISA board in the system, otherwise the resources on the ISA board may conflict with a
BIOS automatically assigns ISA
Notice: IRQ levels, DMA channels, I/O port addresses, and memory addresses defined using this procedure should reflect the same settings defined by supplied jumpers and/or configuration documents.
1.Insert the SCU diskette into drive A: and
2.The SCU Main Menu shown in Table
3.The System Configuration Utility Menu shown in Table
4.The Step 2: Add or remove boards screen is displayed. At this screen select Add by pressing
INSERT.
5.The Add screen is displayed telling you to locate the diskette that contains the .cfg file for the board. Press ENTER at this screen.
Configuring Your System
