Zenith Data Systems MT2000 manual Pentium Pro Processor

5-12

Pentium Pro Processor

The processor/memory board has two sockets for

Pentium Pro Processors.

Installing a Processor

Figure 5-4 illustrates the location for the optional Pentium processor in your system. When adding a second processor, use the same type and speed as the processor shipped with your system. Contact your sales representative.

Notice: Installing a second processor that is of a different type than the first processor, will result in system damage. Do not touch or bend the processor's exposed pins.

The processor upgrade kit contains a DC to DC converter board, processor chip, and heat sink. The heat sink has a heat transfer pad on the bottom and two attached retention clips. To install the second Pentium Pro processor upgrade kit:

1.Remove the processor/memory board as described earlier in this section.

Notice: Observe static precautions. Use an antistatic wrist strap.

Note: Verify that the jumper on the processor/memory board (see Figure 5-4) is set for the correct processor speed. Jumper pins 2 and 3 for 200 MHz and pins 1 and 2 for 180 MHz.

2.Raise the lever on the ZIF socket to the up position (Figure 5-4, A).

Upgrades and Options