Installation

EMG Panic Button (if wired for use in your vehicle)

1)The EMG or Panic Button can be programmed to do many things but may not be connected in your vehicle. Check with your technical department to understand what this button will control before you use it.

2)In Record mode: Press the EMG button on the transmitter, a beep will sound and the relay will be triggered at the receiver.

3)In Standby mode: Press the EMG button on the transmitter, a beep will sound, the green In-Use indicator will blink and the relay will be triggered at the receiver.

Disabling the Beep Sound On the Transmitter

1)All of the audible beep signals on the transmitter can be disabled by setting the BEEP switch to the off position.

Auto Talk (if video recording equipment supports)

1)The Auto Talk feature is used to turn on the microphone whenever the video recorder is turned on. Some video record units can be triggered by other events (lights and siren being turned on etc.) and Auto Talk ensures the microphone starts recording at the same time. The transmitter must be turned on and in standby mode.

2)A +5V signal on the Auto Talk line means the microphone is off.

3)0V or ground on the Auto Talk line turns on the microphone

1.Wire the un-terminated signal wires to the control unit according to the signal chart. A 5 Amp fast blow fuse is recommend in the 12VDC power supply line to protect the equipment.

Audio In

12 FT

Un-terminated wires

Description

Power +12V DC

Video Trigger

(Ground = Transmitter On)

Left Channel (Ground to enable Inside Microphone)

Power Ground

AUX (Panic) Trigger

12V+ DC Output when EMG button is pushed

Auto Talk Trigger

5V+ DC to 0V to turn on mic

0V to 5V+DC to turn off mic

Color

Red

Blue

Yellow

Orange

Black

Brown

Revision B

Page 4 of 9

12/11/08