Sharp PG-F325W specifications Resetting the Lamp Timer of the Projector via LAN

Page 31

Resetting the Lamp Timer of the Projector via LAN

5 Click “Properties” on the “File” menu.

6 Click the “Settings” tab, and then click “ASCII Setup”.

7 Select the check boxes next to “Send line ends with line feeds”, “Echo typed characters locally”, and “Append line feeds to in- coming line ends”, and click “OK”.

•The LAMPRESET Properties window

appears, click “OK”.

8 If a user name and/or password is set for the projector, enter the user name and password.

9

Send the lamp reset command “LPRE0001”.

•This command can only be sent when the projector is in standby mode.

•When “OK” is received, this indicates that the lamp was successfully reset.

10 Close HyperTerminal.

-31

Image 31

Contents Setup Manual Sub 15 pin female connector Connecting Pin AssignmentsConnecting Pin Assignments Computer control Communication conditions RS-232C Specifications and CommandsBasic format W R CommandsDNR BrilliantColorTM OK or ERR PAL Network settings on the computer Setting up the Projector Network EnvironmentConnecting the Pro- jector to a Computer Setting an IP Address for the Computer Confirm or change an IP address for the setup computer Setting up a Network Connection for the Projector DNS Controlling the Projector via LAN Controlling the Projector Using Internet ExplorerVersion 5.0 or later Control Confirming the ProjectorControlling the Projector Status StatusNetwork Security Setting and AdjustingSetting the Security Projector Settings & AdjustmentsGeneral Making General Settings for the Network NetworkSetting for Sending E-mail when an Error Occurs Mail Originator SettingsOccurs Service & Support Access URL Mail Recipient SettingsWhen Connecting Using RS-232C Setting up the Projector Using RS-232C or TelnetClickStartfrom theWindows desk- top and select Run When Connecting Using TelnetAdvanced Setup Menu Setup Menu Main MenuVView All Setting View Setting Detail ListSet Items Tings QQuit Unchanged Save Settings and QuitQuit without Saving Set SSave & QuitUser Name Setting IP Address SettingDefault Gateway Setting Subnet Mask SettingRS-232C Baud Rate Set Password SettingProjector Name Setting Dhcp Client SettingData Port Setting Disconnecting All ConnecSetting Auto Logout Time Entering Advanced Setup MenuCarrying out Network Ping Test Setting of Accept IP Ad- dressAccepting All IP Addresses Return to Default Settings Setting of Search PortReturn to Main Menu Resetting the Lamp Timer of the Projector via LAN Resetting the Lamp Timer of the Projector via LAN Communication cannot be established with the projector TroubleshootingTroubleshooting \ After the initialization, carry out setting again