Sharp PG-F325W Setting and Adjusting, Setting the Security, Projector Settings & Adjustments

Setting and Adjusting the

Projector (Settings & Adjustments)

Example:“Picture”screen display for COMPUTER

On these screens, you can make projector settings or adjustments.You can set or adjust the following items :

• Picture Mode	• Setup Guide
• CLR Temp	• Projection Mode
• BrilliantColorTM	• OSD Language
• Progressive	• Auto Sync
• DNR	• Auto Power Off
• Lamp Setting	• Auto Restart
• Resolution Setting	• System Sound
• Signal Type	• Internal Speaker
• Video System	• Audio Input
• Dynamic Range	• RS-232C Speed
• Resize	• Fan Mode
• OSD Display	• All Reset
• Background

Note

•If you click the “Refresh” button before the screen is displayed completely, an error message (“Server Busy Error”) will be dis- played. Wait for a moment and then oper- ate again.

•You cannot operate this page while the pro- jector is warming up.

•For details about each item, refer to the projector’s operation manual.

Controlling the Projector via LAN

Setting the Security

(Network – Security)

On this screen, you can make settings relat- ing to security.

	Items	Description
User Name		Setting of user name for
		security protection.
Password		Setting of password for
		security protection.
Accept IP		It is possible to set up to three
Address		IP addresses allowing connec-
		tion to the projector.
	All IP	No limits are set to IP addresses
	Addresses	connecting to the projector.
	From only	For security improvement, only an
	specific IP	IP address set by “Address 1-3”
	addresses	can be connected to the projector.

Note

•User Name and Password can be up to 8 characters.

•You can input the characters below : a-z, A-Z, 0-9, -, _

-17