3 SpeedTouch™ System Software Upgrade
3 SpeedTouch™ System Software Upgrade
Introduction Due to the continuous evolution of DSL technology, SpeedTouch™ products are regu- larly upgraded.
This chapter describes how to upgrade the SpeedTouch™ system software.
System software updates
Imperative requirement
Upgrade mechanisms
You can check for system software upgrades regularly at the SpeedTouch™ web site at:
•http://www.speedtouch.com
Firmware upgrades may also be available from your Service Provider. Please contact your Service Provider for more information.
The SpeedTouch™ system software upgrade procedures, described in this chapter are valid for both SpeedTouch™510 and SpeedTouch™530.
However, these procedures are only possible via the SpeedTouch™ Ethernet connec- tion(s).
I.e. to upgrade a SpeedTouch™530, connected via the USB port, disconnect the USB port and make a connection from the PC to the SpeedTouch™530 Ethernet port as described in subsection “1.2.1. Local Ethernet Connection Setup” on page 10, prior to follow the procedures described below.
Depending on your Operating System and specific requirements, following options are available to upgrade the SpeedTouch™ system software:
•In case you run an MS Windows Operating System or Mac OS10:
For your convenience a SpeedTouch™ Upgrade wizard will guide you through the system software upgrade procedure.
See section “3.1 The SpeedTouch™ Upgrade Wizard” on page 34 for more infor- mation.
•In case you run another Operating System, e.g. linux, or for extra information about advanced system software management:
See “3.2 Manual System Software Management via BOOTP Server” on page 39 for more information.
3EC 37891 AAAA TCZZA Ed. 01 | 33 |
|