Sharp XG-P25X Selecting the Economy Mode, Power Save Function, Monitor Out/RS-232C Off Function

Selecting the Economy Mode

These functions allow you to reduce the power consumption when the projector is in standby mode. See page 38 for the procedure details.

Power Save Function

Function to control the quantity of projected light. Select “Low Power Mode” or “Standard Mode” to decrease or increase brightness and power consumption.

Quantity of light is 80%.

Power consumption is 330W.

Quantity of light is 100%.

Power consumption is 380W.

•“Power Save” mode is factory preset to “(Standard Mode)”.

•When selecting “ (Standard Mode)” in “Power Save Mode”, fan noise increases.

•Even when selecting “ (Low Power Mode)” in “Power Save Mode”, fan noise may increase if internal temperature rises enough to activate the cooling function.

Monitor Out/RS-232C Off Function

This projector consumes power when using a monitor connected to the OUTPUT port for INPUT 1, 2 and a computer connected to the RS-232C port. When not using these ports, “MNTR Out/RS232C” can be set to “” to reduce standby power consumption.

Standby power for Monitor Out/RS-232C connection turned off.

Monitor Out/RS-232C on

CAUTION

• Set “MNTR Out/RS232C” to “ ” when using the Sharp Advanced Presentation Software (supplied).

Basic Operation

Automatic Power Shutoff Function

When no input signal is detected for more than 15 minutes, the projector will automatically shut off. The on-screen message, “Power OFF in 5 min.” will appear five minutes before the power is automatically turned off.

Power automatically shuts off after about 15 minutes of no signal input.

Automatic Power Shutoff disabled.

• “MNTR Out/RS232C” is factory preset to “”, and “Auto Power Off” is factory preset to “”.

E-50

XG-P25X/CD (E)-d 50 02.3.19, 7:08 PM