Setting up GyroRemote
The projector uses RF channel and TEACH/LEARN settings to recognize individual projectors that may be operating in the same area, and keep them from interfering with each other. One GyroRemote can operate multiple projectors or you can even use multiple GyroRemotes to control one projector.
Setting RF channels
GyroRemote uses radio signals, which can receive interference under certain conditions. To avoid interference, you can switch RF channels. GyroRemote has 8 channels.
GyroRemote
LED
RF CH
On-screen Display
Confirming the present RF channel
1 Press RF CHlocated on the front, inside the upper cover.
2 The current channel in use is displayed on the lower right of the screen. You can also confirm the RF channel by the number of times the LED flashes.
(Ex: RF Channel 7 if the LED flashes 7 times.)
Switching RF channels
1 Press RF CH for over 1 sec.
2 Each time you press for over 1 sec. the RF channel changes as shown below.
1 
2 
3 
4 
5 
6 
7 
8
3 Each time you change RF channels it is displayed in the lower right of the screen.
•An
Operation Buttons