Vidikron VL-57, VL-52 3Installation, Remote Control, To install batteries in the remote control

Page 25

3Installation

3.1

Remote Control

To install batteries in the remote control:

Battery Installation

1.Slide the battery cover in the direction of the arrow and remove it.

2.Insert the included batteries. Ensure that the polarities correctly match the and markings inside the battery compartment.

3.Slide the battery cover back on until it snaps into place.

1.Do not mix an old battery with a new one or different types of batteries.

Note

2.If you will not use the remote control for a long time, remove the batteries to avoid damage from battery leakage.

•Do not drop the remote control or expose it to moisture or high temperature.

•The remote control may malfunction under a fluorescent lamp. If that occurs, move the LCD display away from the fluorescent lamp.

•Make sure that there is nothing obstructing the infrared beam between the remote control and the IR receiver on the LCD display.

The signal from the remote control can be reflected by walls or other

Note surfaces.

•If the effective range of the remote control decreases, or it stops working, replace the batteries with new ones.

•Ambient conditions may possibly impede the operation of the remote control. If this happens, point the remote control at the LCD display and repeat the operation.

Notes on Remote Control Operation

Vidikron VL-52 and VL-57 Owner’s Operating Manual

13

Image 25

Contents

VL-52 and VL-57 Page For LCD Displays ONE Year Limited WarrantyRIGHTS, Limits and Exclusions Vidikron Important Safety Instructions Declaration of Conformity Compliance InformationFCC Part 1Table of Contents Specifications Maintenance and TroubleshootingOperation Serial Communications1List of Figures List of Figures Xii About This Manual 1IntroductionThey also provide supplemental information Using This ManualPerformance or cause a malfunction If you need Turn toKey Features and Benefits Description, Features and BenefitsOptional Accessories Volume Adjustment Buttons VOL / VOL + Controls and Indicators2Controls and Functions DView at a GlanceCH / CH Power Button Remote Control Sensor Status Indicator LEDINPUT3 Component Video RCA connectors Headphone Jack Main Power SwitchINPUT4 Component Video RCA connectors INPUT2 S-Video InputCable Input VL-52 only AIR Antenna Input VL-52 only DView Remote Control DView Remote ControlOFF / on Memory Preset ButtonsNumeric Buttons Source Selection Buttons4X3 Standard Aspect Ratio Selection Buttons ANA 169 AnamorphicLetbox Letterbox Wide IntelliWideSound Control Buttons Timer OFF ButtonSurrnd Surround Channel Selection Short-Cuts VL-52 onlyRemote Control 3InstallationTo install batteries in the remote control Installation Overview Quick SetupStep Procedure For Details, refer to Wall-Mounting the DView Installation ConsiderationsAmbient Light Antenna/Cable TV Connection Connections to the DViewHdmi Connections Rear of the Display Rear of the PC DVD/DTV STB AV OUT Connections Speakers Optional Connecting ExternalAmplifier Connection Connector Pin AssignmentsRear Panel 4Operation Turning on the PowerChanging the OSD Language Setting the PC Display Properties Using the On-Screen Menus Timer VL-52 Picture AdjustSetup SourceSource Main MenuAspect Ratio Control Description Aspect Ratio SettingsPicture Adjust Perform the adjustments in the order listed hereTypical Gray Bar Pattern for Adjusting Contrast Gray Yellow Cyan Green Magenta Red Blue Typical Test Pattern for Adjusting Sharpness Audio Channel VL-52 only Timer VL-52 only Auto Adjust may take some time to complete, depending on SetupRating/Category Description FCC Ratings and Content CategoriesLetterbox Mode = Letterbox Operation Should be used by ISF-certified technicians only ISF Calibration100 DView Splash Screen Aspect Size Position PIPUsing Picture-In-Picture PIP Video Available Main and PIP Source CombinationsChanging the PIP Size Changing the PIP PositionChanging the PIP Aspect Ratio Images Audio Programs Swap button on the remote controlStereo Sound/SAP VL-52 only Broadcast Mode Receive Mode Mono StereoCompatibility with Stereo and SAP Audio Broadcasts Mono+SAPOperation Cleaning 5Maintenance and TroubleshootingTroubleshooting Tips Troubleshooting ChartComputer Signal RS-232 Connection and Port Configuration Serial Command SyntaxSerial Commands 6Serial CommunicationsS4E Command DescriptionSDB 0027 0024 Serial Communications DView Specifications 7SpecificationsSpecifications are subject to change without notice Weight including stand Regulatory Approvals Limited WarrantyVL-52 Dimensions DView DimensionsVL-57 Dimensions Computer Signal Compatibility Computer/Video Signal Compatibility ChartSignal Mode Vertical Frequency Horizontal Specifications Page Vidikron