Vidikron VL-52, VL-57 manual ISF Calibration, Should be used by ISF-certified technicians only

Page 52

ISF Calibration ➤

ISF Calibration

Picture Adjust

White Balance

Blue Enable

Baud Rate

Factory Reset

Splash Duration

Use the ISF Calibration menu to perform advanced picture quality adjustments. This menu

should be used by ISF-certified technicians only.

You must enter a passcode to access the ISF Calibration menu.

Note

Picture Adjust: The controls in this menu are identical to those in the main Picture Adjust menu, but are accessible only by entering the ISF Calibration menu passcode. This makes it possible to restore the picture quality settings to what they were when the DView was installed, simply by recalling the “ISF Night” or “ISF Day” preset.

•Brightness: Refer to Brightness on page 29.

•Contrast: Refer to Contrast on page 30.

•Color: Refer to Color Saturation on page 31.

•Tint: Refer to Tint on page 31.

•Sharpness: Refer to Sharpness on page 32.

•ADC Phase Adj.: This control works similarly to the Phase adjustment for RGB signals (refer to Phase on page 36). Use it to improve the apparent sharpness of 720p and lower-resolution Component, S-Video or Composite sources. For best results, adjust ADC Phase while displaying a “Sharpness” pattern (Figure 4-5).

•DNR: Refer to DNR on page 32.

•MPEG NR: Refer to MPEG NR on page 32.

•Backlight: Refer to Backlight on page 32.

•Color Temp.: To choose a color temperature setting, select Color Temp. from the Picture Adjust menu and press ENTER. (Color temperature defines the “color of gray.”) The choices are 5400K, 6500K, 8500K and Custom. The default setting, 6500K, is appropriate for most situations. Higher settings produce a “bluer” picture; lower ones impart a reddish hue to the image.

Each color temperature setting has six (6) “white balance” parameters associated with it (two each for red, green and blue). (The White Balance settings for the 5400K, 6500K and 8500K color temperatures are factory-set and cannot be changed.)

To create a “Custom” color temperature, select Custom from the Color Tip Temp. menu and press ENTER. Then, press ENTER a second time to go

directly to the White Balance menu. (This shortcut is available only from the ISF Calibration menu.)

•Gamma: Refer to Gamma on page 33.

•Black Level: This control compensates for incoming elevated black levels present in certain video signals. The default setting (32) results in a minimum black level of approximately 0 IRE. Adjust as needed to match the dynamic range of the source; increase the value if blacks appear elevated (dark gray). If blacks appear “crushed” (too dark), use a lower settting.

40

Vidikron VL-52 and VL-57 Owner’s Operating Manual

Page 51 Page 53
Image 52
Page 51 Page 53
Contents VL-52 and VL-57 Page ONE Year Limited Warranty For LCD DisplaysRIGHTS, Limits and Exclusions Vidikron Important Safety Instructions Compliance Information Declaration of ConformityFCC Part 1Table of Contents Maintenance and Troubleshooting SpecificationsOperation Serial Communications1List of Figures List of Figures Xii 1Introduction About This ManualUsing This Manual They also provide supplemental informationPerformance or cause a malfunction If you need Turn toDescription, Features and Benefits Key Features and BenefitsOptional Accessories Controls and Indicators Volume Adjustment Buttons VOL / VOL +2Controls and Functions DView at a GlancePower Button Remote Control Sensor Status Indicator LED CH / CHHeadphone Jack Main Power Switch INPUT3 Component Video RCA connectorsINPUT4 Component Video RCA connectors INPUT2 S-Video InputAIR Antenna Input VL-52 only Cable Input VL-52 onlyDView Remote Control DView Remote ControlMemory Preset Buttons OFF / onNumeric Buttons Source Selection ButtonsAspect Ratio Selection Buttons ANA 169 Anamorphic 4X3 StandardLetbox Letterbox Wide IntelliWideTimer OFF Button Sound Control ButtonsSurrnd Surround Channel Selection Short-Cuts VL-52 onlyRemote Control 3InstallationTo install batteries in the remote control Installation Overview Quick SetupStep Procedure For Details, refer to Wall-Mounting the DView Installation ConsiderationsAmbient Light Connections to the DView Antenna/Cable TV ConnectionHdmi Connections Rear of the Display Rear of the PC DVD/DTV STB AV OUT Connections Speakers Optional Connecting ExternalAmplifier Connection Connector Pin AssignmentsRear Panel 4Operation Turning on the PowerChanging the OSD Language Setting the PC Display Properties Using the On-Screen Menus Picture Adjust Timer VL-52Setup SourceSource Main MenuAspect Ratio Aspect Ratio Settings Control DescriptionPerform the adjustments in the order listed here Picture AdjustTypical Gray Bar Pattern for Adjusting Contrast Gray Yellow Cyan Green Magenta Red Blue Typical Test Pattern for Adjusting Sharpness Audio Channel VL-52 only Timer VL-52 only Setup Auto Adjust may take some time to complete, depending onFCC Ratings and Content Categories Rating/Category DescriptionLetterbox Mode = Letterbox Operation ISF Calibration Should be used by ISF-certified technicians only100 DView Splash Screen Aspect Size Position PIPUsing Picture-In-Picture PIP Available Main and PIP Source Combinations VideoChanging the PIP Size Changing the PIP PositionChanging the PIP Aspect Ratio Audio Programs Swap button on the remote control ImagesBroadcast Mode Receive Mode Mono Stereo Stereo Sound/SAP VL-52 onlyCompatibility with Stereo and SAP Audio Broadcasts Mono+SAPOperation 5Maintenance and Troubleshooting CleaningTroubleshooting Tips Troubleshooting ChartComputer Signal Serial Command Syntax RS-232 Connection and Port ConfigurationSerial Commands 6Serial CommunicationsCommand Description S4ESDB 0027 0024 Serial Communications 7Specifications DView SpecificationsWeight including stand Regulatory Approvals Limited Warranty Specifications are subject to change without noticeDView Dimensions VL-52 DimensionsVL-57 Dimensions Computer Signal Compatibility Computer/Video Signal Compatibility ChartSignal Mode Vertical Frequency Horizontal Specifications Page Vidikron

VL-57, VL-52 specifications

The Vidikron VL-52 and VL-57 are high-performance projection television models that encapsulate advanced technology and design, aimed at delivering an exceptional viewing experience. Manufactured during an era when home theater systems were evolving, these models became known for their cutting-edge features and superior picture quality, setting a benchmark in the projection television market.

The VL-52 features a 52-inch screen size, while the VL-57 sports a larger 57-inch display, both offering expansive viewing areas ideal for home cinema setups. One of the key characteristics of these models is their use of a high-resolution CRT (Cathode Ray Tube) technology, which provides vibrant colors and deep blacks, enhancing the overall image quality. The zoned convergence adjustment allows users to fine-tune the picture, ensuring that colors align perfectly across the entire screen.

In terms of features, both models support various video formats, including 480i, 480p, and 1080i, allowing for high-definition viewing on compatible content. The inclusion of multiple inputs, such as component, composite, and S-Video, ensures that users can connect a variety of devices, from DVD players to gaming consoles, easily. This versatility makes the VL-52 and VL-57 attractive options for consumers seeking a comprehensive entertainment solution.

The technologies integrated into these models also contribute to their performance. The onboard video processing capabilities enhance image clarity and reduce motion blur, making fast-paced action scenes more enjoyable. Furthermore, both models are equipped with an advanced color management system, which ensures that colors remain true to the source material, providing viewers with a lifelike experience that is reminiscent of the cinema.

Another noteworthy characteristic is the build quality. The Vidikron VL-52 and VL-57 feature a robust and elegant design, making them a fitting centerpiece in any home theater setup. The attractive cabinet work and premium materials used in their construction reflect the brand's commitment to quality and aesthetics.

Overall, the Vidikron VL-52 and VL-57 remain iconic models, blending technology, performance, and design. As home entertainment continues to evolve, these projectors stand as a testament to the innovation that defined their era, offering features and characteristics that can still impress enthusiasts today.
Top Page Image Contents