Attaching the Optional Lens
When you attach a lens for the first time, skip steps 1 to 3. (When you replace the lens, start from step 1.)
Do not attempt to exchange the lens when the projector is installed hanging from the ceiling. Injury may occur if the lens falls.
1 Press STANDBY/ON on the projector or on the remote control to put the projector into standby mode.
•Switch the MAIN POWER switch on the projector to “OFF”.
•Disconnect the power cord and unplug the power cord from the AC socket after the cooling fan stops.
2 Push the LENS RELEASE button all the way in and turn the lens
• The lens will be disengaged.
Note
•If the
STANDBY/ON button
MAIN POWER switch
Power cord
LENS RELEASE button
3
4
Pull the lens out slowly.
Remove the lens cap from a replacement lens.
•Start with this step when you set a lens for the fi rst time.
Info
•If you try to attach the lens to the projector without removing this cap, the optional lens attachment part can be damaged.
26