INPUT button
(ENTER) button P/R buttons
VOL +/– (Volume)
buttons
AV MUTE button
Switching the Input Mode
Select the appropriate Input mode for the connected equipment.
Press INPUT on the projector or on the remote control to display the INPUT list.
INPUT list
INPUT
DVI-D
COMPUTER1
COMPUTER2
COMPONENT
S-VIDEO
VIDEO
•While the INPUT list is displayed, follow the procedure below to switch the input mode.
–Press P/R to select the desired input mode and then press (ENTER).
•If (ENTER) is not pressed, the projector switches to the selected input mode in a few seconds.
Note
•When no signal or
Adjusting the Volume
Press VOL +/– on the remote control to adjust the volume.
On-screen display
Volume |
| 1 |
| ||
|
|
|
Note
•Pressing VOL– will lower the volume.
•Pressing VOL+ will raise the volume.
•When the projector is connected to external equipment, the volume level of the external equipment changes in accordance with the volume level of the projector. Set the projector's volume to the lowest level when turning the projector on/off or when changing the input signal.
•When you do not want to output the sound from the projector's speaker while the projector is connected to external equipment, set “Speaker” in “Audio” of the
•The audio signal is not output from the internal speaker when connecting the audio cable to the MONITOR OUT (AUDIO) terminal.
Displaying the Black Screen | Basic Operation |
and Turning Off the Sound |
|
Temporarily |
|
|
|
Press AV MUTE on the remote control to temporarily display a black screen and turn off the sound.
AV MUTE
Note
•Pressing AV MUTE again will turn the projected image back on.
33