TANDBERG D14129.02 manual Add the system to the network, Verify your settings, Time zone settings

Codec C90

ContentsIntroduction

Administrator Guide

GetGettinging startstarted About the menus About the settings Settings Library Cameras Appendices Contact us

4	Add the system to the network
	Your service provider should have provided you with the information you
	need to get on-line.

For H323 type of communication, this will include such things as system name, H323 alias, gatekeeper address, etc. For SIP type of communication, similar type of information will be supplied.

For networks administrated through TMS (TANDBERG Management Suite), your TMS administrator will be able to assist you when configuring.

The H323 and SIP settings are configured from the Administrator Settings menu:

Navigate to Settings > Administrator Settings > Advanced Settings.

•Expand the items in need of modification and enter the information supplied by your service provider.

5	Verify your settings
	We strongly recommend that you verify the settings by inspecting the System
	Information list.

You do this by accessing the System Information in the same way as you did when you verified you IP address setting.

Go to System Information to verify the settings:

1.Navigate to Settings > System Information

2.Verify the previous configurations. For example, if you successfully registered to a SIP server the Status will show Registered. If the registration failed the Status will show Not registered.

3.Press Home (   ) to exit.

Time zone settings

6	Verify the date and time to see if the time zone settings need to be adjusted. The
	date and time is located in the upper right corner on screen.
	Go to time zone settings to set the NTP (date and time) settings:
	1.	Navigate to Settings > Administrator Settings > Time > Zone
	2.	You may need to consult the NTP Time Zone expression list to find the
		right expression. Go to the Appendices section and the NTP Time Zone
		expression to see a complete overview.
	3.	Enter the time zone expression for where the system is located. The default
		value is Etc/UTC.
		NOTE: Spelling correctly is important when entering the NTP Time Zone
		expression
	4.	Press Save to save the changes, or Cancel to leave without saving.
	5.	Press Home (   ) to exit.

D14129.02—NOVEMBER 2008 12